Bill in Ohio Posted August 28, 2018 Share Posted August 28, 2018 Hello All Fellow Car Lovers. I'm brand new to the Forum. My name is Bill. I love in north-eastern Ohio. I have come across -and- I'm including photos of, what I think, is a 1920 Paige Daytona Speedster! ~It's obviously a relic, but yet amazingly complete: (Engine block with Carburetor, Exhaust Manifold, Vacuum Fuel Pump, Starter, Water Pump, etc.). The Frame suffers semi-moderate rot, but also still retains all four Fenders, 3/4 of the four piece Hood, Firewall/Windshield Cowl, Steering Column, Running Boards, rear Differential, Leaf Springs, Gas Tank and rear Bumpers. (I assume the Transmission and Drive-train are still there, just not un-Earthed (yet). The lack-of metal in the rear of the heap suggests the potential of Speedster rear-end (now gone). Also the split rear Bumpers suggests rear-mounted Spare Tire (again, potential Speedster). I also discovered what I believe is the Drawer-style third Seat. My question is: Is it too far gone? Is it worth saving? I look forward to everyone's professional opinions! Most Kindly, Bill in Ohio Link to comment Share on other sites More sharing options...
Rusty_OToole Posted August 28, 2018 Share Posted August 28, 2018 There are a lot better cars going begging because they are too far gone. That one is a rough condition parts car. Link to comment Share on other sites More sharing options...
1912Staver Posted August 28, 2018 Share Posted August 28, 2018 What makes you think it is a Daytona ? I don't think the part of the cowl where it meets the front of the door is the correct shape for a Daytona however your photos don't show the area well. Daytona doors are very low and the rear edge of the cowl is shaped to suit the door. Your Paige relic looks like it has a standard Roadster or Touring cowl. If it is a Daytona then it is definitely worth saving however I think it probably is not a Daytona. Even a Paige touring owner could probably salvage enough off it to make it worth dragging home however I would not pay more than scrap value for it. Link to comment Share on other sites More sharing options...
wayne sheldon Posted August 28, 2018 Share Posted August 28, 2018 I doubt that it is a real Daytona. But it might be. The cowl doesn't look quite right. The rear bumper looks like the Weed (think tire chains) bumpers Paige used in the mid '20s. The fenders say "maybe?" And if it has the drawer seat, that was a feature used on only a few cars including Kissel Gold Bugs and Paige Daytonas (and a few others including some European stuff). I don't have my reference handy, but if it is a 6-66 Paige? Some parts of it may be worth something (don't think retirement account, it ain't that much). If it was close to me, I could be interested for cheap, only because I like Paige automobiles in general. A few years ago I could have been really interested. But I think I already have enough projects now that will take ten to twenty years more than I have left. Real Paige Daytonas in nearly perfect condition are moderately expensive cars. However, a person could easily spend seventy thousand dollars to turn that pile into a seventy thousand dollar car (IF it is a real Daytona). (Do the math.) Just for references sake, I tried to look up the one that has been for sale for awhile in the UK, but I guess it has been sold. Saw pictures, but no price listed that I found (It must still be out there in cyber-space somewhere?). Link to comment Share on other sites More sharing options...
Anton22 Posted August 28, 2018 Share Posted August 28, 2018 I think it's to far gone to be worth the effort. Link to comment Share on other sites More sharing options...
Restorer32 Posted August 28, 2018 Share Posted August 28, 2018 I would drag it home and ask questions later. Too interesting to abandon if dirt cheap. No pun intended. 4 Link to comment Share on other sites More sharing options...
R Walling Posted August 28, 2018 Share Posted August 28, 2018 Lawn Art. For a restorer shop. Link to comment Share on other sites More sharing options...
Restorer32 Posted August 28, 2018 Share Posted August 28, 2018 We have a '55 Pontiac Station Wagon as our sign. A bit better condition but just as unrestorable. Link to comment Share on other sites More sharing options...
billorn Posted August 28, 2018 Share Posted August 28, 2018 Anything is restorable with enough money. Link to comment Share on other sites More sharing options...
Restorer32 Posted August 28, 2018 Share Posted August 28, 2018 Believe it or not we've done worse or just as bad anyway. Link to comment Share on other sites More sharing options...
Grimy Posted August 28, 2018 Share Posted August 28, 2018 The Continental 10A engine was used in 1925-26 Paige 6-70s, and is a slightly improved version of the earlier 8A and 9A engines, which use the same gasket set. 3.75 bore, 5.0 stroke for 331 cid. I have a backup 10A engine no. 154522 (the subject one is 153601) from a 1925 Paige 6-70, and my slightly later crankcase has a casting date of 6/20/25. So this one is definitively a 1925. The flat radiator means 1924 or later (earlier ones were veed). The Bill Roberts website www.wcroberts.org says that the last Daytona was built in 1923. Wheelbase for the 6-66 (1921-22), and 6-70 (1923-26) is 131 inches. I own a 1922 6-66 Larchmont II 4-passenger sport phaeton. If anyone wants to resurrect this one, I do have available the 1925 6-70 frame and some springs, steering box, and front axle. The trans and rear axle have gone to put other cars back on the road. Link to comment Share on other sites More sharing options...
Rusty_OToole Posted August 28, 2018 Share Posted August 28, 2018 (edited) 14 hours ago, Bill in Ohio said: My name is Bill. I love in north-eastern Ohio. Best idea is to forget the old cars and stick to girls. Edited August 28, 2018 by Rusty_OToole (see edit history) 1 2 Link to comment Share on other sites More sharing options...
Leif Holmberg Posted August 28, 2018 Share Posted August 28, 2018 I think the cowl tells it has been a enclosed car. Leif in Sweden. Link to comment Share on other sites More sharing options...
Frantz Posted August 28, 2018 Share Posted August 28, 2018 Depends how much you want it. I'd love to have a pre war car in that shape to start saving. It's too far gone for sensible folks, but they aren't as much fun to hang out with. Link to comment Share on other sites More sharing options...
Bhigdog Posted August 28, 2018 Share Posted August 28, 2018 Looks like the gas cap is in pretty good shape. Buy that and find a parts car.............Bob 1 Link to comment Share on other sites More sharing options...
60FlatTop Posted August 28, 2018 Share Posted August 28, 2018 2 hours ago, Frantz said: It's too far gone for sensible folks I wouldn't sit around asking questions on a forum when a compelling argument like that says bring it home. Don't wait for the weekend. Do it today! 2 Link to comment Share on other sites More sharing options...
old car fan Posted August 28, 2018 Share Posted August 28, 2018 Bring it home,we live close and have a sedan,parts May fit.Although we can get Hoof,if the tires were not will pops: Link to comment Share on other sites More sharing options...
Bill in Ohio Posted August 29, 2018 Author Share Posted August 29, 2018 Wow! ~Thank You, All! I didn't expect such response, but I truly appreciate all of your replies. You all present valid points of argument. I agree that the shape of the hood-line, following through onto the cowl, curves upward toward the windshield mount area, as apposed to continuing straight across to the doors, as in the Daytona(s). The specific info on Motor Number 10A helps tremendously! ~Thank You. I initially researched Paige engine block numbers, but too no definitive conclusion. Identifying it as a 1925 #6-70 is one question that is now answered. You've all helped me in the decision process -although- I still haven't decided what I'll end up doing about it / with it / if anything. ~Tick Tock. Kindly, -Bill 1 Link to comment Share on other sites More sharing options...
trini Posted September 3, 2018 Share Posted September 3, 2018 There are some parts you might be able to sell. The rest is for the dump. Do not waste time trying to restore that your self. Link to comment Share on other sites More sharing options...
wayne sheldon Posted September 4, 2018 Share Posted September 4, 2018 I will admit that it may not be "good" advice? But I have restored a couple cars from worse over the years. Sometimes the reward is in the accomplishment. 2 Link to comment Share on other sites More sharing options...
Grimy Posted September 4, 2018 Share Posted September 4, 2018 I agree with Wayne, but there is also the consideration of whether a vast number of missing parts are available--unlikely for this Paige. There is always the speedster option... The Paige Daytona which broke 100 mph at Daytona certainly had VERY different gears from even production Daytonas, which are 40-45 mph cars. And likely a number of other differences, because the 8A/9A/10A engines had a 3,000 rpm redline at the very outside. My 1922 Paige 4-passenger phaeton is all in at 40 mph, but it will get a 26 Mitchell overdrive (already on the shelf), not because I want to go much faster but to take the stress off the engine. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now