54vicky

as you said older OH well the search goes on TY

they seem to be more cj oriented TY I will keep searching

I checked the AMC+ forum on here but it looks pretty quite so asking here.a friend bought a jeep pickup(76) the question I (he) wants to know is there any company that sells a upholstery kit he can have an upholsterer install it.the main problem is the ones he has asked said the piping is one problem they run into it is a beige colour.the material would be another.it is a small hounds tooth pattern along with a beige (tan)colour vinyl.do not forget we are up here so do not have the selection you do down there.he would prefer a company up here if possible due to shipping etc.TY in advance

the open - boxed end wrench bottom left looks like some I have in tool box.notice the discoloration from heat being applied to bend

nice to see you solved it.just as an aside the "P" on the flasher stands for pilot.that is for dash lights(indicator)

do not stop until you replace others(pun)😁nice job locating problem

not sure about your problem but if picture is right .that does not look like a "new" fan .new to motor but not new as I know new

not 54 by the trim witness mark but 52-53 probably

I agree with Terry think 55-57 chevrolet

he mentioned it in earlier post Ruko I believe without looking back

a rubber snubber on rear (pan hard bar?) solved it.

you may want a volt meter that reads higher than 11 volts as you should easily exceed that voltage.

just to clarify it is hood ornament

that was simple

what is the verdict?it has been a week

I believe it was a Chevrolet a member of another boar.d I frequent helped build it.

living in a cave might help but be aware of false smoke signals.paranoia is out there

my thoughts exactly my thoughts exactly if it had been suggested right off it would have saved band width.it is one thing to encourage but there are rules.if you want to help you can take it off the forum and use the PM function

if you try solder let us know how that did not work being as you said they are aluminum

be aware that the top 2 on left in the 50s ford (54-55) are definitely wrong and possibly the 52 also.I would question any listed in that as really being as listed

one thing to remember with the factory or possibly haynes etc they do have misprints and mistakes.meaning they are not the end all nice to have but not perfect.

you got me again I even had my glasses on.wether they were clean or not is another matter (lol)

looks to have 2 wings but that is what I see

he probably built his own by now

that is a pretty vague description.p.s. the bore has no bearing on it cutting out