tenugent

Post on ROA forum

#s front of block,infront of carb manifold

Check PM

If the original paint is enamel,lacquer will lift it(craze).

Have a 63 lesabre hood lip in very good condition.No pictures,you pay shipping.

Thanks

Have a 327 30 over,took baffles out of side pipes and is cutting out at higher rpm.Has a edelbroch 650,bigger jets?

Have 327 30 over with edelbrock 650 cutting out after removing baffles from side pipes.Does carb need bigger jets.

No oil in aircleaner.Welcome,think about joining ROA...

Post on buick ROA

Watched a high end painter use wool burnishing pad to take swirls out,no compound.

65 riviera rocker moldings used these.

Install sound deadening on doorskin,did mine sounds like a bank vault when closing

How about the rechromed bumper Ed.

Post on ROA website,that stuff wont last long.you should sell that plated bumper,if its replated it's worth alot.

Jean winfield?

Post on ROA

Body manual shows six,3 on BOTTOM-2 on upper sides-one middle top

It's a 6 blade from a/c #s matching 63 401,could have been changed I don't know.was a running parts car.was a early build,my 63 425 has 5 blades?

I've got a fan and clutch off a 63 401 if you want it

check your pm's

Tom,sorry to say he passed.Had a wake at the zoo-pretty big deal.

2x4 setup chip out of 1 snorkel-63-64-aircleaner blasted and epoxy primed-63 complete set of custom interior 5/16 walnut door panels(mounted)and console pieces-63 console 5/16 birdseye maple pieces-64-65 console 5/16 birdseye maple stained pieces-4 roadwheels-2 sets64 wire hubcaps-1 set 66 hubcaps-5 63 turbine hubcaps with 12 center caps-1 set alum.valvecovers-1 63-64 front bumper-1 63-65 rear tinted glass-other small misc.parts.NO PICTURES.T.E.NUGENT ROA12969.

I made both brackets out of sheet steel,gauge ?Be careful not to break top pivot ball (plastic),l did and had to make one out of a kids jack.

I use tremco demonic fc caulk,its used on commercial buildings around windows.polyurethane sealant,its heavy bodied and paintable. I get it at concrete supply businesses.$5-6. a tube