highcking Posted February 20, 2017 Share Posted February 20, 2017 I'm trying to replace the seals in the front vent windows of my '58 Roadmaster. I have the seals from Steele and I have the window frame and glass out of the car. The problem is installing the window into the seal. The seal is a very tight fit in the channel but I got it in. The window "arm" goes down through the lower part of the seal, no problem. Here things get tough. The upper part of the window frame has a short (1/4") chromed shaft that is supposed to go into a hole in the seal. This part of the seal is thick and solid to hold the window shaft in place. The problem is getting that little shaft into the seal! Despite pushing down on the window as hard as I dare to gain clearance, that shaft will not go into the seal at the top. Anyone else done this task and have a suggestion? Bill Shields Virginia Link to comment Share on other sites More sharing options...
old-tank Posted February 20, 2017 Share Posted February 20, 2017 Napa 7651346 Sil-Glyde Silicone Lubricating Compound Tube, 8 oz 1 Link to comment Share on other sites More sharing options...
Bhigdog Posted February 20, 2017 Share Posted February 20, 2017 Windex............Bob 1 Link to comment Share on other sites More sharing options...
highcking Posted February 20, 2017 Author Share Posted February 20, 2017 Thanks, both good suggestions and both on hand in my shop. It would be interesting to know how the factory did this assembly. Link to comment Share on other sites More sharing options...
buick5563 Posted February 20, 2017 Share Posted February 20, 2017 15 hours ago, highcking said: Thanks, both good suggestions and both on hand in my shop. It would be interesting to know how the factory did this assembly. Practice. Link to comment Share on other sites More sharing options...
JohnD1956 Posted February 20, 2017 Share Posted February 20, 2017 I imagine the assembly order would be: Insert seal in outer frame Insert glass frame in seal Insert glass into glass frame. Link to comment Share on other sites More sharing options...
Bhigdog Posted February 20, 2017 Share Posted February 20, 2017 16 hours ago, highcking said: It would be interesting to know how the factory did this assembly. B F H.............................Bob 1 Link to comment Share on other sites More sharing options...
Smartin Posted February 25, 2017 Share Posted February 25, 2017 The difference between now and factory, is that the factory didn't have reproduction parts that only fit "good enough." 2 Link to comment Share on other sites More sharing options...
60FlatTop Posted February 25, 2017 Share Posted February 25, 2017 On 2/20/2017 at 2:35 PM, Bhigdog said: B F H.............................Bob I was just heading for a Google search. It's already 11 AM where's my head? B Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now