Foxlovescars Posted November 1, 2013 Share Posted November 1, 2013 What is the actual charging voltage "working range" that a 401 with a/c should have? My car usually sits around 12.30 volts when I go to start it, and will sometimes climb as high as 14.50 volts while I am driving (not using the heater, headlights or a/c system). Thanks,Frank Link to comment Share on other sites More sharing options...
1965rivgs Posted November 1, 2013 Share Posted November 1, 2013 What is the actual charging voltage "working range" that a 401 with a/c should have? My car usually sits around 12.30 volts when I go to start it, and will sometimes climb as high as 14.50 volts while I am driving (not using the heater, headlights or a/c system). Thanks,FrankThat`s fine. Most 12 volt batteries will display about 12.4 -12.6 volts while at rest. The charging system should stabilize or regulate at 13.8 to 14.0 volts while the vehicle is running. The voltages will fluctuate depending on the state of charge of the battery and the load being placed on the system. You`re golden, no worries, Tom Mooney Link to comment Share on other sites More sharing options...
Foxlovescars Posted November 20, 2013 Author Share Posted November 20, 2013 Although I had an electrical shop check the charging system and it was okay, my two year old battery continues to slowly "bleed" battery acid from under the top caps when the car is running. When I installed the alternator, I had to install it 180 degrees (upside down from the previous original alternator position) rather than exactly the way the original came off the car. BY ANY CHANCE, would this cause a problem? The connecting wires to the alternator were long enough to allow for the installation reversal.Thanks,Frank Link to comment Share on other sites More sharing options...
JZRIV Posted November 20, 2013 Share Posted November 20, 2013 No problem with the location of the alternator. Most people rate battery quality by how long they last and thats important. Often overlooked and equally important is how well they are constructed to not seep acid around the posts. I've had batteries that rarely ever had to have the terminals cleaned while others its a routine requirement. Acid leakage can be caused by overcharging because the excess gassing can't vent fast enough so an internal pressure builds inside the battery but 14.5 volts max would normally not be a concern. Link to comment Share on other sites More sharing options...
RivNut Posted November 20, 2013 Share Posted November 20, 2013 (edited) When I installed the alternator, I had to install it 180 degrees (upside down from the previous original alternator position) rather than exactly the way the original came off the car. FrankFrank,If for some reason you don't like the placement of the alternator plugs, you can "clock" your alternator. Remove the bolts that hold the cover to the case, rotate the mounting ears to the point where they are in the same location relative to the plug as the original alternator and reinstall the bolts. FYI to anyone purchasing an alternator from your local jobber. Take you old one with you and have the counter person clock the new one AND install your pullies before ever taking it home.Ed Edited November 20, 2013 by RivNut (see edit history) Link to comment Share on other sites More sharing options...
60FlatTop Posted November 20, 2013 Share Posted November 20, 2013 Just be sure someone doesn't slide the body back far enough to let the brushes slip off the ring. It won't charge after that.Bernie Link to comment Share on other sites More sharing options...
steelman Posted November 20, 2013 Share Posted November 20, 2013 Just be sure someone doesn't slide the body back far enough to let the brushes slip off the ring. It won't charge after that.BernieX2 on this. Do not take it apart. Just pull the 4 screws and spin it to the correct position, and reinstall the screws. Link to comment Share on other sites More sharing options...
Foxlovescars Posted January 29, 2014 Author Share Posted January 29, 2014 UPDATE:Clocking the alternator made no difference. Replaced the battery with a new one and the problem cleared up. The battery tested fine under load, but was still bad after only 22 months of service. Could not prove if the battery went bad and started the whole "charges sometime, overcharges other times" problem or whether the battery failed as a result of the bad voltage regulator and/or the old alternator. The charging system seems to be functioning fine now.Thank you again for all your support and seasoned ideas.Frank O'DonnellTroy, VA Link to comment Share on other sites More sharing options...
RockinRiviDad Posted January 29, 2014 Share Posted January 29, 2014 I will be corrected if I'm wrong but I believe the "clocking the alternator" suggestion wasn't to fix your charging problem. But only to help u get the alternator plug positioned back where your original plug sat. Glad to hear your system problem was fixed thoDavid Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now