dibarlaw Posted May 19, 2018 Share Posted May 19, 2018 I finally got around to checking some of the components from the spare 1925 Standard engine we brought back from Louisville. Many things looked better than what was on my car. While my engine is being rebuilt I am getting the best of my spares together to go on it. The heat riser looked to be very good except the inside chamber was coated with oily carbon. I cleaned out most using my friends Blast Cabinet. There was a hole in the center tube. Since this was my spare I thought I would try to press out the tube to replace. I made a driver/plug by turning a shoulder on a threaded pipe coupling and 1/2" black pipe. The tube pressed out easily with out distortion. Now to try to find anything close. The measured sizes for the seamless tubing are O.D. 1.3125, wall thickness is about .032, X 5 29/32" long. I have spent some time looking at tubing and pipe suppliers with no success. So far looking under thin wall tubing most selections are for heavier walls at the 1.3125 O.D. I know Mark Shaw was able to find tubing at a muffler shop to replace his in his 1924 Master. I have contacted every custom exhaust shop in the tristate area and no one carries anything smaller than 1.5" dia. exhaust pipe. I know this from trying to get the heat bypass tubes bent which are 1 1/4" O.D. Any ideas on a supplier? Link to comment Share on other sites More sharing options...
Jim Bourque Posted May 19, 2018 Share Posted May 19, 2018 Hi Larry McMaster Carr has 4130 steel tubing in lots of sizes. This is what I used for my 25 Master. Made a couple aluminum adaptors to fit the tube to chuck in the old South Bend. Interference fit to the tube and warm tube to insert adaptors. Turn to what you need for OD. I used .065 wall thickness. Warm tube again to get adators out. Jim 1 Link to comment Share on other sites More sharing options...
Leif Holmberg Posted May 19, 2018 Share Posted May 19, 2018 Larry. Check the tube on an old vacuum cleaner,if remember right i have used that on my 1925! Leif in Sweden. Link to comment Share on other sites More sharing options...
Mark Shaw Posted May 20, 2018 Share Posted May 20, 2018 Larry, I suggest you try looking for European or British car exhaust tubing.... Smaller cars = smaller exhaust. Link to comment Share on other sites More sharing options...
Roger Barrett Posted May 20, 2018 Share Posted May 20, 2018 We have always had to custom make these tubes to suit the parts at hand. Simple lathe work. Link to comment Share on other sites More sharing options...
dibarlaw Posted May 21, 2018 Author Share Posted May 21, 2018 Thanks Roger: That is what I will probably do by using Jim's technique. Making some end adapters and then turning down between centers on my old 10" South Bend. Thanks for all the suggestions. Larry Link to comment Share on other sites More sharing options...
Grant L. Meredith Posted June 13, 2018 Share Posted June 13, 2018 small old tractors had tubing that small on some......might get lucky at a tractor supply shop! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now