mikewest

The engine is for sale. Im asking $5000.00 for it. I have the intake manifold ,carburator,magneto and other smalls. Mike West

Ive mailed out my original parts for patterns to my friend Bob Nauman in PA . He has a shop that can handle the job. Thank you for all the responce to my post! Mike

Can anyone suggest a foundry in the east that will cast parts in Iron? mwest729@aol.com

jOE tHANK YOU FOR THE OFFER BUT THAT IS NOT WHAT iM LOOKING FOR Im looking for a timer only Mike

I need a 6 cly timer for a early engine.All considered,mwest729@aol.com Thank you Mike 585 738 1541

I have original books forsale . $100 includes postage Book like new mwest729@aol.com

JELP Are these parts for sale?? Mike 585 738 1541

For auction rust free 51 Super convertible on EBAY Low reserve has been met... Search 1951 Buick Super convertible and see the auction.

Wanted a 6 cyl timer for a early car with both battery and magneto ignition. Make not a concern. Email mwest729@aol.com or call 585 738 1541 Thank you

Jerry Contact the Franklin club . They have a supplier for certain models with 14 inch drums.

I need a 6cyl timer for a 1910 project ,anyone having one please contact Mike 585 738 1541 Thank you

Bob ,I think "one could read anything they wanted into that statement".But I also think you are right on about the frame improvement. Mike

Gentlemen, Thank you for your efforts ! I appreciate your time and responce. Thank you, Michael West

Can you tell me what this rear was originally fitted too?? year and make?? Mike

Does anyone reading this have any information on the operation/adjustment on a Hele-Shaw clutch unit made in the early teens ,used in a FWD truck?Id appreciate anything you have to offer. Thank you Mike

Bubba Where is the car located? Mike

Ill take th e tire and get at Hershey Please email me where to send the $20.00 to and your Hershey space. Thank you Michael West NY 585 738 1541

Bill Ill take the generator ,please send a picture to mwest729@aol.com Thank you Mike

The date is Jan 1913

any ideas?

Check out the new post on the Horseless carriage or what is it on this site for 1913 engine

See other pictures in "WHAT IS IT"

more pictures

Here is a early engine I bought at a farm sale. It has a place for a timer on the rear like a Selden did. I have a flywheel and cone clutch also. The port plugs are probably in the barn I will go back and see. There are no breaks or welds. Any ideas what it may fit?The outside diameter at just above the base of the clys is 4.750. That leads me to believe the bore is at least 4.00 and as big as 4.250. Mike 5857381541

Ed what size is the piping and what are the hole sizes in the flanges and spacing center to center? Mike