Robert G. Smits Posted May 29, 2023 Share Posted May 29, 2023 This is in a 90 Series parts car I purchased non running in the early 90’s. I am planning to fill the cylinders with lubricant for a few weeks before trying to see if it is stuck. My thoughts are Marvel Mystery Oil versus a mix of ATF and Acetone. Any recommendations appreciated Link to comment Share on other sites More sharing options...
Mark Shaw Posted May 31, 2023 Share Posted May 31, 2023 No need to fill the cylinders. Squirt a couple of ounces in each cylinder via the spark plug holes. Then drop the pan and lube the crank and cam bearings etc. Lube everything that moves. Note that Acetone is only a carrier for the ATF to penetrate tight places. It evaporates almost immediately and does not lubricate. 1 Link to comment Share on other sites More sharing options...
BlueDevil Posted May 31, 2023 Share Posted May 31, 2023 I am using a combination of Evaporust/acetone and ATF. I will let you know how it works out. Link to comment Share on other sites More sharing options...
Joe Cocuzza Posted May 31, 2023 Share Posted May 31, 2023 Also good options if all else fails: Kroil Diesel Fuel 1 Link to comment Share on other sites More sharing options...
Robert G. Smits Posted June 4, 2023 Author Share Posted June 4, 2023 Thanks all. I never thought about Evaporust. Has anyone else used it on a stuck engine? I think I will add some. Link to comment Share on other sites More sharing options...
edinmass Posted June 4, 2023 Share Posted June 4, 2023 I would not use evapo rust to free a stuck engine. I’m a fan of it but not on a frozen engine. Use a borescope an look in the plug holes. See if you’re dealing with just slight surface rust or an actual hole that was water filed for years. Taking apart a stuck 16 is ten times more difficult than an eight. Having worked on one extensively………there is a lot of stuff to get stuck on that thing. If the plugs have always been installed and it isn’t locked up rusty…….I would use ATF. Also using an oil pressure pot to pressurize the engine before you try and get it free is a good idea. On engines such as these, oftentimes the motor is stuck from oil turning into a type of glue…….and rust may not even be an issue. I have found pumping 180 degree hot water through the block for a few hours will often soften up the old congealed oil and make it turn without any issues. Stuck valves and lifters, and bound water pumps are common. Don’t assume a stuck engine is only pistons and rings causing problems. The late series V-16 engines are exceptionally hard to find as a spare…….several people I know are looking for an engine. Take car not to damage anything….or lose any hardware…..it’s miserable to try and locate. 2 Link to comment Share on other sites More sharing options...
Robert G. Smits Posted June 5, 2023 Author Share Posted June 5, 2023 16 hours ago, edinmass said: it’s miserable to try and locate Thanks Ed, I was hoping you would post This engine came from a collection in Missouri and was always inside. In then last 30 years it has been in CC storage. I plan to look inside with a borescope this week. Thanks for your other suggestions I hadn't thought of. Link to comment Share on other sites More sharing options...
sprkplug57 Posted February 8 Share Posted February 8 Would you be interested in sharing some pictures of the top part of this engine with the air cleaners removed showing the the linkage, fuel and vacuum lines. Gary Seymour Newport Vermont Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now