Replaceing rear brake springs on my 56 Windsor

[torry61]

I had to replace the R/R wheel cyl on my Windsor. Other than bending the drum with the puller, it went fairly smooth, UNTIL it was time to hook up the brake springs. What's the secret? I'm considering trying a come-along!

Thanks:(

[keiser31]

Just use the correct brake spring tool and keep your eyes protected.

Edited March 24, 2011 by keiser31 (see edit history)

[Rusty_OToole]

Slide them on with a big screwdriver. There is a knack to it.

[Guest rsd9699]

I also use a long handle screwdriver and safety glasses. Those springs are POWERFUL and can jump for yards. After 10 or so attempts with a screwdriver to keep it centered you will get the hang of it. Also a small pair of vice grips can be of assistance in controlling the spring movements while under pressure.

Ron

[keiser31]

Slide them on with a big screwdriver. There is a knack to it.

I used to do it that way and it works VERY well.

[Rusty_OToole]

To control the spring if it goes flying you can hold it with vice grips or tie a rag around it.

[61polara]

For saftey sake, buy a brake spring tool.

[Guest PJNicks]

Did you use the the C-845 puller that Chrysler recommends. I am about to embark on the job and would like some help finding the right puller. i also have a 56 windsor.

[JACK M]

You need a puller that is held with the lug bolts. DO NOT pull on the drum.