mcCat1962 Posted August 18 Share Posted August 18 We are running a 29 Whippet engine in our 27 Whippet and we have had some issues with the water boiling over. Generally this only happens on very hot days (90 degrees +), and only after driving the car for an average of 20 minutes or more. We have pulled the radiator and back flushed the system (everything was pretty clean) and we have checked the water pump and the impeller appears to be moving the water. We have done some research on the Internet and we have some period repair manuals, however they all seem to say the same thing, check the pump and flush the system. We are using an original radiator that appears to be in very good shape with no leaks and does not appear to be clogged anywhere. I know that old engines sometimes over heat and it may just be the hot weather, however any suggestions would be greatly appreciated. Thanks Link to comment Share on other sites More sharing options...
wayne sheldon Posted August 19 Share Posted August 19 (edited) Is the radiator a cellular or honeycomb type? Cellular type (including honeycomb) radiators are notorious for developing scale inside over years of use with dirty or hard water. They can be very difficult even practically impossible to clean. However, there is a heated and circulated "Evaporust" method of cleaning them that has had remarkable results! I am lousy with searching websites, but edinmass went to great lengths a few years back to chronicle in detail the process with great results. Several people have duplicated his method with similar results. It is of course very possible that the engine itself is your problem. Do have any history for the engine? If I recall correctly, 1927 Whippets were only four cylinder models, and a six was added to the line in 1928. Both fours and sixes were continued until the Whippet was rolled back into the struggling Willys. Carburetion and/or ignition issues or adjustments can cause overheating of the engine. Head gasket failures or cracked blocks or heads can also result in overheating. The worst overheating I ever had in an antique automobile was a model T Ford with a crack in one of the combustion domes in the head. Good luck and welcome to the forum for antique automobiles! WE hope you stick around and become a regular here. Edited August 19 by wayne sheldon I hate leaving typos! (see edit history) 1 Link to comment Share on other sites More sharing options...
CarNucopia Posted August 19 Share Posted August 19 What are you using for coolant? The “standard” 50/50 mix does not transfer heat as well as straight water. During the hottest months, I use a higher percent of water and add Water Wetter. It runs cooler and recovers more quickly. Link to comment Share on other sites More sharing options...
28 Chrysler Posted August 19 Share Posted August 19 Are you topping off the radiator to just below the overflow? In these cars the radiator top tank acts as an expansion tank. As the water heat it will increase in volume. With an inferred non-contact thermometer check the upper and lower radiator temp as well as the front and back of the head and block. Link to comment Share on other sites More sharing options...
Mark Shaw Posted August 19 Share Posted August 19 Do the simple stuff first... Verify the suction side hose is not collapsing after coming up to temperature. Do not overfill the radiator. Only an inch or two should cover the core of the radiator. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now