Rock10 Posted May 2, 2021 Share Posted May 2, 2021 Does anybody know the thread size on the water temp sender hole? We finally got the last of the old probe out today and the threads have taken a beating. Link to comment Share on other sites More sharing options...
37_Roadmaster_C Posted May 2, 2021 Share Posted May 2, 2021 I have a new temp gauge for our Roadmaster and I am sure it is the same as the Special. I will be out to the car in a day or two and will check and measure it. You may get an answer sooner, but I will check. 1 Link to comment Share on other sites More sharing options...
Ben Bruce aka First Born Posted May 2, 2021 Share Posted May 2, 2021 I do not know the answer to your question, but may have the answer to why it is, /was a problem. The rocker arm stand directly above the sender and each spark plug is a THROUGH hole. If someone sometime had the rocker arms off and did not use the proper shorter bolt in the stand above the sender it can go through and bind the sender bulb. Good luck Ben 2 Link to comment Share on other sites More sharing options...
Buick35 Posted May 6, 2021 Share Posted May 6, 2021 I think they're a pretty standard size. I didn't trust the gauge in my 35 Buick so I mounted an under dash temp.gauge from the local parts store and it screwed right in to my block. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now