Jump to content

Need instructions on replacing keyless entry module


carbuff

Recommended Posts

My 1989 Reatta keyless enty module does not work. I assume the panel behind passenger seat can be removed by removing the 3 screws next to the trunk pass through hole and then prying the panel off. Please advise if this is the proper way to get to this module. Is the module fastened by a retention wire clip or is it bolted down. Any suggestions as to where to purchase the module at a reasonable price. My dealers price is $425 and they are not sure they can locate one. Thank you

Link to comment
Share on other sites

contact Jim Finn JFinn@cpinternet.com he should be able to hook you up with a new module.

I'm recollecting this from a while ago, but I believe you'll have more to remove than just 3 screws. I think you'll need to remove the 'B' Pillar trim, including the seatbelt outlet and coathook, the center top cover over the third brake light and then the curved lower trim panel (I think there are screws along the top of the panel you'll need to access).

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...