carbuff

Can I reach this module through the trunk without removing the driver side comaprment panels? Is the module retained by a clip versus screws. Thank you.

My 1989 Reatta keyless enty module does not work. I assume the panel behind passenger seat can be removed by removing the 3 screws next to the trunk pass through hole and then prying the panel off. Please advise if this is the proper way to get to this module. Is the module fastened by a retention wire clip or is it bolted down. Any suggestions as to where to purchase the module at a reasonable price. My dealers price is $425 and they are not sure they can locate one. Thank you

Thank you for your help.

My 1989 Reatta computer monitor has a (Present Avg MPG reading) I cannot find any place in the owners manual how to reset to zero and restart this calculation. Any suggestions?

Thank you for your insight.

My 1989 Reatta windshield has many rock chips in it. I found and purchased a good windshield taken out on another Reatta. The windshield molding encapsulation was damaged upon removal by a glass company. The glass company in my home town is reluctant to install it because some of the encapsulation is missing. Can I remove all of the encapsulation and then have a glass company put a new molding around it upon installation, or would I be better off trying to find another glass company who will try to add to/repair the original encapsulation? Thank you for any advice.

I ran an error code check on my 1989 Reatta and a got the following reading: C553 History, where can I find out what this error code is?

Could be torque locking and unlocking since it is worse when the transmission is cold. Thank you for yor advice

The overdrive seems to go in and out too frequently. What activates it? Is it a vacuum or electrical activation? Is the activation unit inside or outside of the transmission? This problem happens at various speeds from 35 mph plus. When the transmission is cold the problem seems to be worse. Any suggestions as to the problem and a fix would be appreciated.

The heater stopped putting out heat. I checked the door linkage behind the glove box and the door seems to open and close. I replaced all the vaccum hoses in the engine compartment that I could find and still no heat when set at maximun heat. Any suggestions?

I have several burnt out bulbs in my 1989 Reatta LH front park & signal lamp. I would like to remove the whole lamp and replace all bulbs. How many screws hold this lamp in place and can they all be removed from the underneath the car without taking anything else apart?

I need to replace the left cornering lamp bulb. What is the best way to access the lamp socket to change this bulb?

Most likely your door lock acuator is not strong enough to make it unlock. I just installed a new one on my 1989 Reatta and also lubed all door lock mech. I could get to. The units sold on Ebay come from China and they do not work in cold weather.

I have a 1989 Reatta with a damaged hood emblem. I purchased a replacement emblem and it is 2 inches across and the one on my car is 3 inches across. Which size hood emblems came on which model years? Someone may have put a newer hood on my car explainig the difference in the replacement size.

I cannot find the one touch entry system control box on my 1989 Reatta. I have looked in the trunk behind the driver's side shelf speaker and it is not there. I want to program my key fab. Any suggestions on where else to look?