Hawkin Posted July 4, 2005 Share Posted July 4, 2005 You can start it with a jump but it only runs for like a couple seconds then dies. Is this a sensor problem? Any help ya'll could give would be greatly appreciated.Thanks! Link to comment Share on other sites More sharing options...
Guest Posted July 4, 2005 Share Posted July 4, 2005 The alternator is not putting out enough amperage to recharge your battery. have the alternator checked out, especially under load (air conditioning on/radio on/lights on). Bryan MoranBCA 28571 Link to comment Share on other sites More sharing options...
JohnD1956 Posted July 5, 2005 Share Posted July 5, 2005 Are you sure the fuel pump is working fully? Sounds like it is killing the battery and still not charging the system to full pressure.John D Link to comment Share on other sites More sharing options...
Reatta Man Posted July 5, 2005 Share Posted July 5, 2005 If it starts and runs briefly, it very likely sounds as if it is the oil level or oil pressure sensor. If they read a low level of oil, or low pressure, they will shut off the fuel pump. You could find the sensors, disconnect the leads and see if it will start. If it does the same thing, you could jump the connections of one sensor at a time and see if it will start and run. If it does, and you are certain it has plenty of oil and good pressure, just replace the defective sensor. If the fuel pump were the problem, I don't think it would start and run at all. Joe Link to comment Share on other sites More sharing options...
JohnD1956 Posted July 6, 2005 Share Posted July 6, 2005 Building on Reatta Man's post, if you do find the oil low, watch for a bad gasket at the timing chain cover in the area of the oil pump. Mine blew out in the 70K range and didn't leak at an idle, but poured out at 1500 RPM. The local dealer claimed this was common on this vintage engine, although I never heard of it before.JD Link to comment Share on other sites More sharing options...
Glassesguy Posted July 9, 2005 Share Posted July 9, 2005 JD:Had that happen to me a few years ago with my 95 supercharged Riv. Mileage was somewhere in the 70s. Engine leaked enough even at idle that I had it towed to the dealer for repair. More labor cost than parts. Link to comment Share on other sites More sharing options...
Hawkin Posted July 10, 2005 Author Share Posted July 10, 2005 I finally tracked down the problem. So we tested the fuel line and found it to have only 5lbs. pressure. Not good. Replaced the fuel pump and now it runs like a dream! Link to comment Share on other sites More sharing options...
NTX5467 Posted July 11, 2005 Share Posted July 11, 2005 IF you haven't already done so, DO add a fresh fuel filter to the system too!IF the current filter is clogged somewhat, it can still seem to be fine but will "kill" the new pump and possibly harm the wiring in the sending unit too (if it's not a complete module). Pump works harder, wires get warmer, insulation melts somewhat = failed pump over time. Plus try to not let the fuel level stay below about 1/4 tank if you can help it. The fuel surrounding the pump helps cool it plus the pump running "dry" is another "kill" contributor. When the "Low Fuel" light triggers, there's only like 2-3 gallons in the tank (sloshing around).On most any late model GM port injection system, it takes a minimum fuel pressure to fire the injectors. If the pressure is not "there", even if it's only a few psi lower, it'll crank and crank and not start . . . until the pressure reaches the min spec pressure . . . if at all.Glad you discovered the problem and got it fixed.NTX5467 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now