Brian_Heil Posted September 19, 2022 Share Posted September 19, 2022 Any info or leads appreciated PM me Thx! Link to comment Share on other sites More sharing options...
Mark Shaw Posted September 19, 2022 Share Posted September 19, 2022 Got a photo?? Link to comment Share on other sites More sharing options...
Brian_Heil Posted September 20, 2022 Author Share Posted September 20, 2022 No Helping a non internet owner who contacted me. I could post a pic of a 1917 Buick Link to comment Share on other sites More sharing options...
Oldtech Posted September 20, 2022 Share Posted September 20, 2022 Model? Link to comment Share on other sites More sharing options...
Brian_Heil Posted September 20, 2022 Author Share Posted September 20, 2022 6 cylinder 1 Link to comment Share on other sites More sharing options...
Mark Shaw Posted September 20, 2022 Share Posted September 20, 2022 Like this one? 2 Link to comment Share on other sites More sharing options...
Brian_Heil Posted September 20, 2022 Author Share Posted September 20, 2022 If you could take some measurements I will pass them on to him. He said his shroud was Swiss cheese. How is this one? Link to comment Share on other sites More sharing options...
Brian_Heil Posted September 21, 2022 Author Share Posted September 21, 2022 His dimensions from the front Link to comment Share on other sites More sharing options...
pepcak Posted September 24, 2022 Share Posted September 24, 2022 Am I wrong in assuming that 6cylinder model would have crank hole in the rad shell, whereas 4cylinder model has it in the apron panel? Link to comment Share on other sites More sharing options...
Brian_Heil Posted September 26, 2022 Author Share Posted September 26, 2022 On 9/24/2022 at 9:01 AM, pepcak said: Am I wrong in assuming that 6cylinder model would have crank hole in the rad shell, whereas 4cylinder model has it in the apron panel? I'm no 1917 expert but a Google image search would say 'yes'. Link to comment Share on other sites More sharing options...
Oldtech Posted September 26, 2022 Share Posted September 26, 2022 It's not extremely difficult, if you have any sheet metal ability, to make a new lower section and splice it in. The bottoms are always swiss cheese. Mine looked like the picture above. This is the finished product. 3 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now