highcking Posted June 26, 2022 Share Posted June 26, 2022 My Buick's master cylinder came with a threaded steel plug where the brake light switch installs. I forgot to install the switch before I installed the master cylinder so I had to do it with fluid in the cylinder. I purchased a “Standard” brand in the box from an eBay vendor. I followed some online advice to prevent air getting into the system and this worked like a charm. I filled the switch with brake fluid, wrapped the threads in Teflon, and did the quick swap. A very small amount of fluid dripped into the shop rag. Now I come to my question. I was wearing rubber gloves and quickly turned the switch in with my fingers. After a few seconds of turning (maybe 3-4 full turns, I didn’t count) I suddenly realized the switch housing was turning but not the threaded piece. I stopped immediately, cleaned up the dripped fluid and ran a few tests. It’s not leaking even after depressing the brake pedal (engine off) 10 or so times. The switch itself works just as it should. I haven’t done one of these switches in a long time. Opinions on what happened? Defective switch from China? I can’t locate any specific directions on how to actually install the switch. Thoughts welcome. Note that the picture is generic - ignore the numbers. Bill in Virginia Link to comment Share on other sites More sharing options...
Bloo Posted June 26, 2022 Share Posted June 26, 2022 (edited) I don't know. I think I have seen those loose before. I don't really think they are supposed to be. The old ones weren't loose. Generally speaking, the quality of Standard these days is downright embarrassing. Oh how the mighty have fallen. There is a bright side though. I bought one of those Standard switches about like yours and it worked fine, and has been working fine for 4 years or so. Also, it had a suffix on the part number when compared with the old part number (maybe an "L"?) that means it comes on with less pressure than the old ones did. That is always a good thing. I would clean it up real good and keep an eye on it, and if it's not leaking and the brake lights are working I would run it. Edited June 26, 2022 by Bloo (see edit history) 1 Link to comment Share on other sites More sharing options...
Bill Shields Posted June 26, 2022 Share Posted June 26, 2022 Bloo, thanks for the observations. That's my current plan. If it leaks, I'll see if I can find another brand made in the USA. But I fear all the brands are made in that cursed China. 1 Link to comment Share on other sites More sharing options...
rodneybeauchamp Posted June 28, 2022 Share Posted June 28, 2022 There are some recent good posts on using different switches that activate the lights on with less pressure. One mentioned was from Harley-Davidson and another brand. Worth looking at those if swapping it out. just my two bobs worth Rodney 😀😀😀😀😀 1 Link to comment Share on other sites More sharing options...
Bill Shields Posted June 28, 2022 Share Posted June 28, 2022 I checked the switch for pedal pressure with the engine off. It activated with modest pressure. With the booster operating, I think it would be quite sensitive. But I didn't like what it did when I turned it in by hand. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now