leomara Posted June 3, 2020 Share Posted June 3, 2020 How many were used, where did they go and what size were they. I know odd questions but someone was overzealous with wood putty on the body skeleton and filled in most of the holes.....yikes! Link to comment Share on other sites More sharing options...
JFranklin Posted June 3, 2020 Share Posted June 3, 2020 Maybe you need to crawl under with a drop light. It might reveal an answer. Link to comment Share on other sites More sharing options...
leomara Posted June 3, 2020 Author Share Posted June 3, 2020 Great Idea and thank you. I did that, but should I just assume because you see a hole in the top of the frame it was for a body bolt? Link to comment Share on other sites More sharing options...
JFranklin Posted June 4, 2020 Share Posted June 4, 2020 Ah, now I see the conundrum . I guess you could run a 1/8 drill bit through from the underside and see if it comes out in a fairly logical place. I would bet both sides would at least have the same amount like maybe 4 on each side. Bodies in general have one in each corner, one on either side of the seat area, and usually the same somewhere in the forward part of the trunk. Good luck. Link to comment Share on other sites More sharing options...
viv w Posted June 4, 2020 Share Posted June 4, 2020 Start at the front, 2 at front of cowl, 2 at door hinge pillar, probably 2 at door shut pillar, maybe 2 half way between the shut pillar and rumble seat floor and most likely 2 on the outside of frame just behind the rear axle(there is a bracket at this point). Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now