broker-len Posted August 19, 2016 Share Posted August 19, 2016 I am trying to connect a screw head to a small badge may be aluminum tried JB weld looking for other ideas bobnroman@yahoo.com Link to comment Share on other sites More sharing options...
joe_padavano Posted August 20, 2016 Share Posted August 20, 2016 Are you trying to get a threaded stud on the back of this badge for mounting? If so, you need a lot more surface area than that screw head. Consider starting with a trim clip like one of these. Remove the wire, as you won't need it in this application. You need to rough up both the back of the badge and the head of the clip. You then need to thoroughly clean both mating surfaces with lacquer thinner. Don't touch them after cleaning. JB Weld should be more than adequate for this task if proper surface preparation and application is followed. 1 Link to comment Share on other sites More sharing options...
Spinneyhill Posted August 20, 2016 Share Posted August 20, 2016 (edited) I have used cyanoacrylate gel for those sorts of jobs. Clean and full contact (no gaps) are important. Edited August 20, 2016 by Spinneyhill (see edit history) Link to comment Share on other sites More sharing options...
joe_padavano Posted August 20, 2016 Share Posted August 20, 2016 20 minutes ago, Spinneyhill said: I have used cyanoacrylate gel for those sorts of jobs. Clean and full contact (no gaps) are important. I agree, IF the surfaces are clean and full contact, as you point out. I fear that it will be difficult to achieve those conditions on the parts shown in the first post. JB Weld is much more tolerant of poor fit-up. I've also used a similar product in aerospace bonding applications where fit-up was a problem. ScotchWeld 2216 is an excellent two-part epoxy that will accommodate gaps in the mating surfaces. It isn't cheap, but it works well. McMaster Carr and other sources sell it. Link to comment Share on other sites More sharing options...
Friartuck Posted August 20, 2016 Share Posted August 20, 2016 (edited) I have used PC7 with good success. PC7 Paste type of epoxy. I like Joe P's idea of using the threaded stud, but one possible problem is the stud length. If the purpose is to go through a radiator, perhaps a Tee nut or regular nut epoxied and use a threaded rod cut to length. Edited August 20, 2016 by Friartuck (see edit history) Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now