Smartin Posted June 22, 2015 Share Posted June 22, 2015 There are a couple open ends on these lines that I am reinstalling in the 54, and need to see where they go. I cannot find any routing diagrams in the chassis manual. Link to comment Share on other sites More sharing options...
Leif Holmberg Posted June 22, 2015 Share Posted June 22, 2015 This`s is for 1956 I think.Leif in Sweden Link to comment Share on other sites More sharing options...
1953mack Posted June 22, 2015 Share Posted June 22, 2015 There are a couple open ends on these lines.....With or without power brakes?With or without the electric vacuum pump? Al MalachowskiBCA #8965"500 Miles West of Flint" Link to comment Share on other sites More sharing options...
MrEarl Posted June 22, 2015 Share Posted June 22, 2015 (edited) here is the diagram for 54-55 windshield wiper and washer vac lines. and a couple pics from my Century, for purpose of routing the lines only, don't pay any attention to anything else other than routing as there is a lot of incorrectness. Edit) Basically and which is not shown well in the picture the short line from the brass elbow on the manifold (in front of carb) goes to the left bottom side (right if you are standing in front looking down at it) of the fuel/vac pump and the long vac line goes from the right bottom side (left if you are standing in front looking down at it) of the pump to the Y of the wiper wash lines. Edited June 22, 2015 by MrEarl lousy depiction in pictures (see edit history) Link to comment Share on other sites More sharing options...
Smartin Posted June 22, 2015 Author Share Posted June 22, 2015 Thanks guys. WITH power brakes and electric vacuum pump. I was more or less looking for the wiper/fuel/vac pump routing. I think we're good, and it is as I expected. Link to comment Share on other sites More sharing options...
MrEarl Posted June 22, 2015 Share Posted June 22, 2015 I don't think I ever knew it had power brakes. Hopefully the Power Brake Master Cylinder (booster) is good? Link to comment Share on other sites More sharing options...
Smartin Posted June 23, 2015 Author Share Posted June 23, 2015 Not sure. I have fluid to all wheel cylinders and no pedal. I think the MC is toast. That is the project after I get it running. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now