Zimm63 Posted December 10, 2011 Share Posted December 10, 2011 Are there any differences in the rear axles used in the 63, 64, and 65s? I've got a line on a posi from a 64 and want to be sure it will fit my 63.Any help out there?ThanksZimm Link to comment Share on other sites More sharing options...
Jim Cannon Posted December 10, 2011 Share Posted December 10, 2011 I am pretty sure it will not. I think the drive shafts are different, where they attach to the pinion. Get pictures of the pinion and compare to what you have on the '63. Link to comment Share on other sites More sharing options...
RivNut Posted December 10, 2011 Share Posted December 10, 2011 Jim,My '63 has a u-joint on the pinion shaft and my '64 has a flange on the pinion shaft. I think that if you pulled the u-joint off the '63 and the flange off the '64, the actual 'pumpkins' are the same.Ed Link to comment Share on other sites More sharing options...
1965rivgs Posted December 10, 2011 Share Posted December 10, 2011 Ed is correct. You will need to change the `63 yoke for the `64. Be careful when you run up the nut, not too tight, not too loose. There is a crush collar on the pinion and when you are tightening the nut you are putting preload on the bearing...not too tight, not too loose... Tom Mooney Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now