Guest lw46wc20 Posted December 30, 2009 Share Posted December 30, 2009 I have new glass installed in the winshield frame. What's the trick to get the outer rubber molding seated into the windshield frame? Link to comment Share on other sites More sharing options...
Larry Schramm Posted December 31, 2009 Share Posted December 31, 2009 On some of these installations you might need to get the molding real warm in hot water and then insert into channel Link to comment Share on other sites More sharing options...
nickelroadster Posted December 31, 2009 Share Posted December 31, 2009 Use a piece of cotton cord about 3/16" thick and wrap it around the slot in the windshield gasket. You can then set the lower part of the gasket slot on the lower frame. When you pull the cord from the inside of the car, it will pull the lip of the rubber past the windshield frame and seat it all around. It helps to have two people to do it and you might have to try it a couple of times until you get the right touch. Another helpful item that you can find at a parts store is a 6" to 8" suction cup that can be attached to the windshield to make handling it a little less awkward. Link to comment Share on other sites More sharing options...
Guest lw46wc20 Posted December 31, 2009 Share Posted December 31, 2009 Thank you both for replying. This is a swing out winshield were a rubber seal attaches to windshield frame and seals to the body when closed. I will try Larry's suggestion of using hot water. I have been using a hair dryer and soapy water, but can't seem to get both lips of the seal to lock into the slot of the window frame, especially around the corners. Tried a thin string and various putty knives and screw drivers. I will keep trying. Thanks for your help Link to comment Share on other sites More sharing options...
Bhigdog Posted December 31, 2009 Share Posted December 31, 2009 Silicone spray. I hate getting that stuff any where near a car but it does work...........Bob Link to comment Share on other sites More sharing options...
Guest lw46wc20 Posted January 1, 2010 Share Posted January 1, 2010 Bob,Good idea, I will pick a can up. For the data base, I found that the channel slot fro the rubber around the corners still had some surface rust and not as clean as they should have been. This channel at the corners seemed to be bent tighter than the straight areas. I lightly tapped on the frame to bend and open the channel a tad. Using vaseline and a window spline roller tool, I have managed to get about 25% of the gasket installed thus far. Thank you for your help. Link to comment Share on other sites More sharing options...
Guest Robin Coleman Posted January 4, 2010 Share Posted January 4, 2010 Forgive me for saying this, but using vaseline or any other petroleum based product on any rubber product is not good. The rubber will degrade more rapidly if you do so. Link to comment Share on other sites More sharing options...
Guest kaycee Posted January 5, 2010 Share Posted January 5, 2010 I do'nt know if this would work, but how about trying brake fluid or Armorall on the rubber gasket? Just be Ultra Careful if you try brake fluid around a painted windshield frame or any painted surface. kaycee Link to comment Share on other sites More sharing options...
Rusty_OToole Posted January 5, 2010 Share Posted January 5, 2010 Aren't you supposed to wrap the rubber around the glass then press the channel over both at the same time? With the help of a rubber mallet?Just asking. I have not done this job before. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now