1949Chrysler Posted October 28, 2023 Share Posted October 28, 2023 Wiring Harness from the Trunk area: Back up Lights, Brake Lights and Gas Tank Sending Unit. How does this wiring assembly route? Does it rest upon the "floor" under the carpet? Along the Drive Shaft Tunnel? In my photo I have it taped down and questioning my route. Any suggestions? --Brian Link to comment Share on other sites More sharing options...
tom1954 Posted October 29, 2023 Share Posted October 29, 2023 I do not know anything on a 49 but I can tell you that on a 54 that loom runs up along the roof line them back down at the " A" pillar. Link to comment Share on other sites More sharing options...
c49er Posted October 29, 2023 Share Posted October 29, 2023 On your C46 T&C it does run over the floor along side the frivets side rubber step sill mat..but under the carpet. Link to comment Share on other sites More sharing options...
1949Chrysler Posted October 30, 2023 Author Share Posted October 30, 2023 18 hours ago, c49er said: On your C46 T&C it does run over the floor along side the frivets side rubber step sill mat..but under the carpet. Thanks very much for the reply. So I currently have it taped in the general area. Regards, Brian 1 Link to comment Share on other sites More sharing options...
marcapra Posted December 17, 2023 Share Posted December 17, 2023 I'm wiring my 48 DeSoto right now, and the car literally tells you how to route the harness. It has clips in the engine compartment and up the A pillar and along the left side of the roof, then down into the trunk area. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now