Sensor #

[Y-JobFan]

Anyone know the right GM # for the Crank Position?  Also, I need to get a puller, don't need the best one on earth but one that will work, any recommendations? Thanks 

[Ronnie]

This is the one I installed about a year ago on my Reatta. 
Amazon.com: Delphi SS10208 Engine Crankshaft Position Sensor

 

Normally a puller isn't needed unless you are working on a '91 model. It should slide right off once the bolt is removed. This How-To guide on ROJ will be helpful. 
Reatta Owners Journal - Crankshaft Position Sensor Replacement

 

 

[Y-JobFan]

Watched the video and worked on mine today expecting to see similar, when I got in there this is in front of the harmonic balancer whereas the LeSabre had direct access to it.  So what all needs to come off to get to it?

[2seater]

The 88 Reatta doesn't have that little shock either. On later models, you need to remove the nut on the lower end of the shock and the three bolts that attach the bracket itself to the engine. After that just the big bolt in the center of the balancer.

[Y-JobFan]

1 hour ago, 2seater said:

The 88 Reatta doesn't have that little shock either. On later models, you need to remove the nut on the lower end of the shock and the three bolts that attach the bracket itself to the engine. After that just the big bolt in the center of the balancer.

Thanks, wasn't expecting to run into that lol 

[Y-JobFan]

All done and running like a champ again