Gary W Posted July 21, 2021 Share Posted July 21, 2021 Here is the link to the discussions regarding the headlight switch and the multi beam system. When I stepped on the dimmer, the drivers headlamp went out completely, instead of going to a "low beam" or a "cross beam" situation. I finally found a good restored headlight switch, but have not installed it yet. Being I never drive at night, it hasn't been an issue so far, but its on my rainy day list. Bloo is correct that one of the internal "triangles" is shaped differently and if they are not in the correct places and orientations the system doesn't operate as designed. Good Luck with it! Gary 2 Link to comment Share on other sites More sharing options...
dibarlaw Posted July 22, 2021 Share Posted July 22, 2021 (edited) Gary: Even after rebuilding the switch mine does the same thing. The drivers side goes out. I usually drive at night with the switch pulled fully out and the high beam on so I have both lights on. How my switch was. Those darn triangle contacts! I filled the burned areas with epoxy and polished the contacts. Edited July 22, 2021 by dibarlaw Added content (see edit history) 1 Link to comment Share on other sites More sharing options...
Bloo Posted July 22, 2021 Share Posted July 22, 2021 Do I see the biggest triangle in the middle? I don't remember for sure what order they go in, but that looks wrong to me. Link to comment Share on other sites More sharing options...
dibarlaw Posted July 22, 2021 Share Posted July 22, 2021 Bloo: I have another switch laying around so I may pull that apart to verify. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now