fsnooks Posted May 14, 2020 Share Posted May 14, 2020 Starter side works OK. How do I test output voltage? Can i adjust voltage. It appears low. Link to comment Share on other sites More sharing options...
Mpgp1999 Posted May 16, 2020 Share Posted May 16, 2020 With the proper 10a fuse you can test the voltage with a volt meter. Run the motor and touch the positive and negative leads while giving the motor some throttle. There are two screws one locking hex bolt and the other adjusts. When running you can loosen the hex and adjust the output. Make sure the brushes are in good condition and the commentator is clean. Also watch the amp meter on the dash. 1 Link to comment Share on other sites More sharing options...
fsnooks Posted May 18, 2020 Author Share Posted May 18, 2020 Are these the 2 nuts? The one of left is tight. right one is a little loose. Link to comment Share on other sites More sharing options...
cahartley Posted May 19, 2020 Share Posted May 19, 2020 Yes, one is for the adjusting rack pinion and the other holds it in place once adjusted. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now