'50 Interior Door Access Panels

[beerczar1976]

I was able to pull door access cover panels from an ebay seller. For whatever reason, my car as purchased from PO, didn't have them. What is the correct thickness of the rubber bumpers that attach to the top side of the triangular bracket? CARS sells at least two different thicknesses. As I understand, the windows when lowered are supposed to rest on top of these brackets/stops. The rear door covers are the only ones with these brackets. This must stop the window from going all the way down; I know many modern 4-door cars do not allow the rear windows to go down all the way leaving an inch or two of glass sticking up above the door frame when fully down. The front covers are just that, they cover over the access hole. I'll try to dig back thru all the various manuals that I have to see if they call out the right thickness.

[buick5563]

I believe those are just bumpers to prevent harming the bottom channel. Lower your window to where it looks good and measure the distance. I honestly doubt that 3/8 vs 1/2" will make a difference.

[old-tank]

I usually find the bumper that I need in the bottom of the door