tony1970

its way up under the drivers side dash panel

Hi Murray pull the speakers out ,on the speaker it should tell you the ohm if they are delco factory speakers the ones in the rear are 10 ohms if I am not mistaken,you can buy these on ebay size 4/10 for the rears.the fronts I never replaced.

HI I have 90 conv,and I do not have a strap like that I do not know why it is there.

Yes I always use it ,please keep it going Ronnie. Thanks Tony.

Thanks Jim for the pictures.After seeing whats involved I have decided to leave alone,again thank you for the pictures.

HI does anyone have one of these for sale? Its to illuminate the drivers door keyhole on a 90 reatta. my wire broke off from the connector that goes to the courtesy light.thanks

Hi Ronnie I have the same set up one question ,is there a bulb on the bottom of the white connector? If so mine is missing that's why it is not working.Do you know if that bulb is replaceable?

Hi Ronnie ,What is the optical light guide and where is it located?

Thanks Scott for your information this wire at one time broke off the connector that goes to the courtesy light I stripped a little of the wire reconnected it with no luck,.

H I everyone,is there a optic wire for this and where is it located? The light show works perfectly except for the drivers side key hole.Can someone help me with this,thanks T ony.

Good mourning Barney and happy new year.I replaced the headlight switch and wala everything works the way it should! Thanks Barney.

Hi everyone, hope all had a good holiday.Getting back to the headlight problem.They are working fine.Just one thing with the the headlights on the ac controller,radio and console lights are not on ,only when I put the fog light switch on they work.My question is Is this normal? Also everything works fine just with the parking lights on I do not have to turn on fog light switch.I need some help to figure this out.Thanks Tony.1990 reatta conv.

Hi Ronnie,Thanks for asking about the headlights I have been very busy in the last couple of weeks. So far all I have done was swap out the headlight switch . It seems to be working fine so far,but I still think there is a dead spot in the motor.After the holidays I will take both motors a part and look in to it further . I will be taking the car out tomorrow for a 50 mile trip . Have a good holiday ,thanks Tony.

Hi Barney, I want to thank you for your feedback for my headlight problem. I have been away for the last couple days ,when I get some time I will check the motor out for dead spots and let you know. Thanks Tony.

Hi Harry,the headlight motor knob was very tight. I turned it a few times just to get it loose the covers were not raised.thanks tony.

Hi Dave ,good to hear from you I will take it apart and have a look as soon as it gets a little cooler.

Thanks Barney for your feedback, I started the car up today and lights went up and worked fine ,although I loosed the headlight motor knob last night because lights did not go up but they were on, sometimes only the drivers side will go up and the other side will not .I hit the headlight switch again and they worked fine. I think it could be the headlight switch or something binding on the crank arm. What say you.thanks tony.

Hi Ronnie been away for a while but I am back ,I have had time to check out the headlights car has been sitting for a while here in florida at 85 degrees in the garage I tried to turn on the headlights but did not go up ,but the lights were on ,loosended the motor knob and they went up I have ruled out the switch ,was say you thanks tony,

Hi Ronnie it is a 1990 reatta conv I did update my profile .I wiil let you know what I find.

Hi Ronnie thanks for your feedback it happens to both headlights. I did lube the pivot points with motor oil .as I am this I went out to check the lights and they work fine.i am thinking maybe it is the switch.what say you?

HEADLIGHT MOTORS how do I a just the the headlight motor tension ? I went to go put my headlights today they not go until I loosened the wheel the on the motor then they worked fine any feed back would be great both motors were rebuild 2 years ago thanks tony.

HI to every one ,decided to refurbish my steering wheel today every thing was going fine till the air bag slipped off the steering while I was reaching for a tool on the floor ,it pulled the horn wire out of the steering column and snapped a piece off tan plastic . now the wire will not make a connection .the horns were working fine before this happened,i checked the relays and fuses all good ,I checked the horn wire to battery all good I tested the contact inside the steering column it lights but noticed its off center,does any won know what this part is called? And does any one have one for sale? and what has to be done to replace it?any help would be great thank tony.

With out this forum this car dead,nobody knows how to fix this car. when I have to bring it to repair shop they do even know what it is,even a buick dealer has problem simply they do not have smarts or the tech 1 tools they need to fix car never mind brake system.A little story I had a abs light on since I bought this 5 years ago I tried everything on my own and failed if it wasn't for dave telling me about my front wheel sensors even though they check good they were still bad so I make investment with dave and the light has been off ever since it is thanks to people like him, that keeps the forum alive! now every works in this car except the cigarette lighter heating element, looking to purchase one,other than that this car is driven every day,i will post pictures soon

Hi Dave guess what ? ABS LIGHT IS OUT! I I used both of your sensors I guess there both good I wiil mail you out another check,if you want my old sensors let me know that way I can put the check in the box,again I want to thank you for helping me out this light has been on ever since I bought this car 4 years ago now thanks to you everything works in this car perfectly.thanks tony.

Hi Ronnie ,yes I am.