super55 Posted April 4, 2005 Share Posted April 4, 2005 I was looking at the oil pan and it looks awfully tight to be able to drop it without raising the engine or something. Can the pan be dropped as-is? If not, how is it done? Link to comment Share on other sites More sharing options...
Guest AWBE Posted April 4, 2005 Share Posted April 4, 2005 I drove my 55-76R up on some of those metal ramps-----but be sure you properly chock your rear wheels Link to comment Share on other sites More sharing options...
Bhigdog Posted April 4, 2005 Share Posted April 4, 2005 remove idler arm from frame. Lower steering relay rod. Remove exhaust crossover or "Y" pipe. There are holes in the frame to acess forward 4 pan bolts. A real miserable job........Bob Link to comment Share on other sites More sharing options...
super55 Posted April 5, 2005 Author Share Posted April 5, 2005 Need some clarity. If I put the car up on ramps, can the oil pan be removed without dropping the idler arm, etc? Or is this gonna be a full day job with lots of headaches? Link to comment Share on other sites More sharing options...
old-tank Posted April 5, 2005 Share Posted April 5, 2005 The idler arm is the least of your worries...just 2 bolts on the right frame rail and pull the draglink down, remove the crossover pipe, remove the oil filter and the flywheel cover at the lower front of the transmission. The ramps should not be and obstacle other than having to crawl around under the car like a lizard. I have a service pit in my shop and the last time I had to R&R a pan on a 55 it took about 3 hours. This was on a recently assembled engine...could take a lot longer if the crossover/manifold/exhaust pipe fasteners have not been removed in a long time. Also I had to loosen the rest of the exhaust system since the exhaust pipe needs to go back about 2".Have fun!Willie Link to comment Share on other sites More sharing options...
Bhigdog Posted April 5, 2005 Share Posted April 5, 2005 Like OldTank said. Idler arm is easy part. If your Exhaust system is newish it's meerly a pain in the butt. If the flange nuts are rusted to the exhaust manifold studs and you twist the studs off.........well, you get the point. It's anywhere from a 2 hour job to a burn the damn thing where it sits deal. You pretty much must remove the whole exhaust system. When you put it back together use brass or stainless nuts and anti sieze....Bob. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now