olefre Posted April 8, 2019 Share Posted April 8, 2019 (edited) I need the lower control arm LH for 1948 Chrysler New Yorker conv. Edited April 8, 2019 by olefre (see edit history) Link to comment Share on other sites More sharing options...
JACK M Posted April 8, 2019 Share Posted April 8, 2019 Where are you at olfre? If the Windsor is the same I have a parts car you can pull one from. Its probably going to scrap soon. Located in NW Oregon. Link to comment Share on other sites More sharing options...
c49er Posted April 8, 2019 Share Posted April 8, 2019 (edited) The 1946-48 8 cylinder Saratoga, NewYorker and Imperial cars use the larger threaded bolt pin A-Arms. Sedan, cpe, and convert all the same arms upper and lower. Six cylinder car A-Arms won't fit. Smaller threaded bolt pins. Edited April 8, 2019 by c49er (see edit history) 1 Link to comment Share on other sites More sharing options...
olefre Posted April 9, 2019 Author Share Posted April 9, 2019 Thanks c49er, I thought that was the case. Do you have the partno for the correct control arm? Link to comment Share on other sites More sharing options...
olefre Posted April 9, 2019 Author Share Posted April 9, 2019 Thanks Jack M. First I am in Norway, so pulling the arm from your car would be difficult! Also the Windsor parts will not fit, but thanks any way! Link to comment Share on other sites More sharing options...
JACK M Posted April 9, 2019 Share Posted April 9, 2019 Dang, wont fit, I will bet you were looking forward to the trip too. Oh well, good luck with this. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now