tcslr Posted September 17, 2011 Share Posted September 17, 2011 is there good guidance on how to properly polishing points and electrical contacts? fine grit emery cloth?demin?What do you folks who drive your cars do?Thanks, Tom Link to comment Share on other sites More sharing options...
Guest billybird Posted September 17, 2011 Share Posted September 17, 2011 I have found Scotch Bright pads to be pretty good on stuff like that. Link to comment Share on other sites More sharing options...
hchris Posted September 17, 2011 Share Posted September 17, 2011 When cleaning up ignition points the emphasis should be more on getting a nice flat surface on both contact surfaces rather than "polishing" the surfaces; a good clean electrical break as the contacts open enhances the sparking properties. To that end a small flat file is best, although a little awkward to use in situ, emery cloth is good, I would shy away from scotch pads as they are likely to leave small fibres in place.Any good tool shop should have "points files" over the counter. Link to comment Share on other sites More sharing options...
Guest noncompos Posted September 17, 2011 Share Posted September 17, 2011 I saw somewhere (but can't find in manuals at hand) that one should file and polish in the direction the points "wipe" as they open and close...you should make sure you've got both contacts smooth before setting, as snags or high spots will throw gap off...Of course, that's the ideal...I usually ran mine until they began to stick shut at low speed (going around corners) whereupon I'd jump out with my wife's (or appropriate persons') fingernail file, pop off the cap, give 'em a couple swipes, and go on... Link to comment Share on other sites More sharing options...
Rusty_OToole Posted September 17, 2011 Share Posted September 17, 2011 When reviving an old motor that has been out of commission for years it is often necessary to clean the points. A points file works well for this. If you do not have one, a strip of 600 wet or dry sandpaper folded double works well. Follow up with a shot of electrical contact cleaner or brake kleen spray and drag a strip of white paper between them until it comes out clean.This is for ignition points which are made of hard tungsten. Some points are made of soft material like silver, used in Chrysler transmission controls. On those you have to be more careful, use the cleaner spray wipe and the white paper.For switches etc just the contact cleaner usually works. If you can get the switch apart and get at the points a gentle wipe with 600 paper may be appropriate. These switches usually have copper contacts which are also softer than ignition points.The contact cleaner or brake kleen spray is usually safe. WD40 will work too in many cases. Link to comment Share on other sites More sharing options...
Guest rsd9699 Posted September 30, 2011 Share Posted September 30, 2011 A shop manual for your car will detail the in and outs of point cleaning - generally for the cars with a generator and regulator - that info would apply to most all hard metal points - not the copper or silver points. Most recommend a rife spoon file.Ron Link to comment Share on other sites More sharing options...
Guest Al Brass Posted October 2, 2011 Share Posted October 2, 2011 Modern replacement points should not be filed or faced because they have a tungsten coating. If you file that away, they will not last well at all.Al Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now