Guest justjoe Posted March 20, 2011 Share Posted March 20, 2011 I am putting my engine back together and have the intake and exhaust manifold mounted loose. On the rear stud is just a alignment pin, but the next one towards the front does not have a boss on the manifolds. It has been about a year it has been apart and did not take photos before I took it apart. The manual does not show any illustrations as to what goes where. your input would be greatly appreciated. Also is that special rectangle washer need to be installed horizontally or vertically. Link to comment Share on other sites More sharing options...
Larry Schramm Posted March 20, 2011 Share Posted March 20, 2011 Looking at the first picture, it would seem to indicate that there should be a long bolt (maybe 2 inches) installed with a large washer or cross bar that goes over the two bosses that are on the manifolds to hold them down and in place. Link to comment Share on other sites More sharing options...
Ben Bruce aka First Born Posted March 21, 2011 Share Posted March 21, 2011 That is correct, Larry. Ben Link to comment Share on other sites More sharing options...
50jetback Posted March 21, 2011 Share Posted March 21, 2011 Larry and Ben are both correct.The part you are looking for ( presumably you dismantled ) is a long bolt with a heavy steel bracket, maybe 1/4" thick or more. The end that sits on the intake manifold boss is cut-away to follow the round countour of the manifold tube. Link to comment Share on other sites More sharing options...
Guest justjoe Posted March 21, 2011 Share Posted March 21, 2011 Thanks, I'll need to start looking for it. Have no idea what I did with it. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now