-
Posts
297 -
Joined
-
Last visited
Content Type
Forums
Gallery
Events
Posts posted by NCBRIJEN
-
-
Thanks Barney. Question: is the Reatta emblem size on the 15" and 16" the same or different ?
-
-
Looking for a 1991 Reatta hubcap in any condition. I appreciate any leads and responses. Thanks y’all!
-
-
10 hours ago, Barney Eaton said:
BOOREATTA (Chuck Kerls) Passed away in early December....his widow may have other Reatta items for sale, I know he owned a Pewter Reatta model.
So sorry to hear that, god bless Chuck and his family 🙏
-
Just missed this 😞
-
-
The Vehicle has 180.000 miles the dash cover just protects the dash no cracks or damage. Yes the drivers seat bolsters could be refreshed.
-
-
-
Thank for the suggestion, i will look into that as a possibility. I am not sure if the "check engine " light stays on... I will check that this weekend.
- 1
-
Vehicle runs smooth and shifts with no issues until I receive this alert on the CRT screen and then starts to shift hard like it goes into "Limp mode"
What could be the issue... just a sensor?...the dealer charged $150.00 to reset the code ( by disconnecting the battery and it ran fine for about a week until the alert again pops up almost everyday now...?
-
-
-
Some Premium American Motorcars of the Reatta in
RED WHITE & BLUE !
From the Reatta section of the BCA @ Charlotte Motor Speedway Auto Fair Spring 2018.
including our Select Sixty ?
- 2
-
Barney: I hope all is well. I will be sending you the antenna from the 1989 again w/check. Thanks.
On 3/20/2013 at 9:56 PM, NCBRIJEN said:Barney: I will be sending mine to you in a week or so to the address you listed above...with the check.... My 89 just went out today after 24 years....
Thanks,
Brian
.
-
On 1/16/2018 at 12:24 AM, KDirk said:
As far as vertically aligning the front bumper, I've found that it is good to support them with a wood block on a floor jack under the center when reinstalling them to be certain they are tight against the bottom edge of the front filler panel before tightening the bumper mounting nuts. Back bumper installation benefits similarly.
OK how do I go about doing this... where are the front bumper bolts located exactly .. and how many are there? Looking at it now..are there other parts that must also be removed to accomplish this? Has anyone made a video on how to do this?
-
I am looking for a "like new" or NOS blue in color rear passenger & rear driver roof assist handle w/light for my 1991 Buick Park Avenue. I had the headliner professionally replaced and unfortunately the shop broke off the coat hanger clip from the unit on both the passenger and driver side.... I believe the part number is: 25510714 but not 100% sure...
I appreciate any and all leads...
-
Winning bid:US $6,450.00
-
Looks like a very well taken care of Reatta available on Ebay for those interested...
-
-
E-85
in Buick Reatta
4 minutes ago, handmedownreatta said:the whole claim against ethanol is that the alcohol in it attracts moisture which causes the steel gas lines and tank to rust and that it eats the seals in the fuel system.that's why i pay extra for ethanol free gasoline.
I also use only Pure Gasoline in all vehicles below 2002 that were not designed to burn ethanol ... including all yard tools and Marine vehicles. Every Gasoline station around me all have 100 % pure pumps for this reason.
- 1
-
another ad for the convertible,,,,wish I could find another ad that shows the convertible in a compete view..... anyone find one?
- 1
-
Really liked the Motorweek review of the 1990 convertible, thanks Frogware!
Here are a few print ads I like:... I also have these framed in the garage..
- 3
Looking for Center Cap for 1991 Reatta Part Number 3521602
in Buick Reatta
Posted
Thanks rogold99, Barney and Dave! I appreciate your input. I have always thought they were the same size but never seriously measured.... either one of ya'll coming to the Charlotte Auto-fair this year? Its been awhile. 🙂