Jump to content

Ereatta

Members
  • Content Count

    25
  • Joined

  • Last visited

Community Reputation

0 Neutral

Profile Information

  • City, State, Country
    New York

Recent Profile Visitors

65 profile views
  1. Ereatta

    Stalling

    just filled the tank and its running fine with normal idle
  2. Ereatta

    Stalling

    With the key to run or engine on and idle? What would that indicate, padgett?
  3. Ereatta

    Stalling

    So it's definitely the fuel pressure when there is half a tank. Barney, is this the correct tutorial?
  4. Ereatta

    Stalling

    Okay. 89 Reatta . Your really Bidening me right now, Ronnie. So after an a.m. of stalling and hours of crank and no start. Just now I filled two more gallons of fuel and it started. This only leaves one culprit, the fuel assembly hoses, any nay sayers? Fuel Tank To Filler Tube Hose Replacement tutorial is this the correct tutorial on this ? Thank you for your response
  5. Ereatta

    Stalling

    .4 at idle and smooth increase to 4.28-30
  6. Ereatta

    Stalling

    Thank you for your very informative response, so replacement without adjustment first?
  7. Ereatta

    Stalling

    "WOT" While .... ....? the tps doesnt go over 2.3 when revving while idle
  8. Ereatta

    Stalling

    okay. 1st try : the reading first springed to 42 then to 35 and gradually to 32 2nd : sprung up to 42 then again rapidly movement to 35 then gradually quick to 24 3rd: 42 for 2 seconds than same and gradually down to 22 psi i have the recording of the test on video, does not fit in this reply
  9. Ereatta

    Stalling

    Is it the same procedure with the vacuum pump as the gauge?
  10. Ereatta

    Stalling

    So basically, complete overhaul? 😊
  11. Ereatta

    Stalling

    Those 3 in the first picture, and the bottom one in the 2nd picture I swapped with new, the one going to the brake pedal is difficult to track. So if the vacuum tubes are still intact but have that crumbly feel, it is best to change with new?
  12. Ereatta

    Stalling

    I feel like it would drive fine if the tank is full. Does the gas tank need to be drained to check the fuel pump and connections around it? I do believe there is a cruise control error, The one that says "cruise control may be disengaged or something". I haven't driven it in a while so... these errors come up only when I drive around a bit. I replaced a few vacuum tube connections, but when I listen closely around the air filter area, still sounds like a leak. So is 245 in the ecm okay for a knock sensor? I think I'm going to try this step as well "Pull the vacuum line off the fuel pressu
  13. Ereatta

    Stalling

    if the fuel supply is inadequate would the sensor show lean? There is only one sensor? I'll change the oxygen sensor and go from there?
  14. Ereatta

    Stalling

    Okay, so I went to the ECM level, everything seemed in range, except the oxygen sensor voltage was .2 ED07 Knock sensor activity was at a whopping 245 ED17 oxygen sensor cross counts ED18 was 0 The throttle position sensor was .42 at idle as soon as i drove it out of the parking it stalled I'm going to inspect the vacuum tubes again
×
×
  • Create New...