aussiecowboy Posted May 25, 2014 Share Posted May 25, 2014 I know this is a long shot but I am looking for the synchronizer assembly for a 32 Pontiac V8, for some reason it was removed from my car at some point. I need the arm inside the timing cover as well as the outer arm or any individual parts I can get.I am also searching for 4 of the small handles for the bonnet (hood) vents.I am in Australia but would be delighted to pay postage.With thanksHeath Link to comment Share on other sites More sharing options...
aussiecowboy Posted May 27, 2014 Author Share Posted May 27, 2014 I'd be grateful for any drawings, pictures or measurements also. Link to comment Share on other sites More sharing options...
aussiecowboy Posted May 31, 2014 Author Share Posted May 31, 2014 Still looking. Link to comment Share on other sites More sharing options...
jim43 Posted May 31, 2014 Share Posted May 31, 2014 How are you for wood spoke wheels? I know of a couple nice ones about that year. Link to comment Share on other sites More sharing options...
aussiecowboy Posted June 1, 2014 Author Share Posted June 1, 2014 Hi Jim, thanks for your reply. My 32 has wire spoke wheels so wooden wheels aren't much use to me. I do have a 27, 29 and 30 on timbers however.CheersHeath Link to comment Share on other sites More sharing options...
mercer09 Posted June 6, 2014 Share Posted June 6, 2014 The handles for the hood vents may be identical for a Chevy, which is a bit easier to find. Link to comment Share on other sites More sharing options...
aussiecowboy Posted June 12, 2014 Author Share Posted June 12, 2014 Good advice, thanks. They do look the same, looks like I can even get reproductions, I didn't think of Chevy. Link to comment Share on other sites More sharing options...
BYmechanic Posted July 10, 2014 Share Posted July 10, 2014 Greetings from BC. CanadaAt the moment there are eight 1932 Chevrolet door vent fingers up for bid on ebay. The bid is at $9.50 + shipping. Bidding closes in the next 10 hours.I own a 1932 Chevrolet coupe and I also have half of a 1932 Pontiac hood (top and right side). The fingers are the same as the ones on my Chev.I hope this helps. Cheers! Marv Link to comment Share on other sites More sharing options...
aussiecowboy Posted July 11, 2014 Author Share Posted July 11, 2014 Hi Marv, thanks for the tip but I actually bought 8 brand new reproduction pieces from The Filling Station, fit is reasonable. The pontiac hood doors have a very slight curve to them which the finger pulls do not have so the pointy end stands slightly proud of the door, you have to be very close to notice it however.CheersHeath Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now