1923 Buick 44 Roadster

[Brian T. S]

Hello, new to this forum.

 

I need some help.

 

I'm trying to figure out if I have the right size bows, when I lowered the bows they were catching on the bolts for the bow saddles versus by passing and laying on the trunk. This is for Buick 1923 44 Roadster. See attached photos.

 

Thanks in advance,

 

Brian

 

 

[EmTee]

Try posting your question here: https://forums.aaca.org/forum/60-buick-pre-war/

 

I'll bet someone over there can help...

[Brian T. S]

Thanks, EmTee

[Gunsmoke]

Is your car similar to this one, 1923 Buick type 54? The rearmost bow it appears should land in saddle close to anchor bolt, subsequent bows remain above the mentioned bolt. None of the bows should land on rear deck. I note this car has deck cleats, does yours need then? Check for old holes in rear deck from underside. Over time the curvature of some old bows might distort, narrowing (or widening) them at sharp curves, causing imperfect fit.

Edited April 18, 2022 by Gunsmoke (see edit history)

[Brian T. S]

Thanks much! Its similar. No holes on the body so I probably don't need them. This is really reassuring information. I think I can get it to work with a little adjustment.

 

Thanks again,

 

Brian