jekeys1 Posted October 29, 2020 Share Posted October 29, 2020 Looking for a set of .030” over pistons for a 1927 Model 36. The cheapest new set so far is $1,600 including rings and pins. Just checking all my options to help the customer out. Bore = 4.030” Compression Height = 3.250” with dome Dome = .250” Pin = 1.080 currently Link to comment Share on other sites More sharing options...
edinmass Posted October 29, 2020 Share Posted October 29, 2020 Don’t run the factory pistons. They fail........Been there, done that. 1600 is more than the 1200 I would expect. Be careful who you use.......lots of problems with established companies lately. PM me for additional insight. Do yourself a favor........you can’t build a Pierce motor on a budget. They are expensive.......and short cuts will cause them to pop. Link to comment Share on other sites More sharing options...
jekeys1 Posted October 29, 2020 Author Share Posted October 29, 2020 So far, nobody has forgings with that tall of compression height, so they would have to be billet. I figured I'd try the slim chance someone has an aftermarket set on the shelf. Ed, we had a conversation about pistons at Amelia, I had the 14' Lozier parked 2 trailers down from you. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now