07 HD Posted May 26, 2019 Share Posted May 26, 2019 (edited) 67rivi@gmail.com Edited May 26, 2019 by 07 HD (see edit history) Link to comment Share on other sites More sharing options...
Larry Schramm Posted May 26, 2019 Share Posted May 26, 2019 Do you have a picture? There might be one grease fitting on the side of the axle and/or one on the top of the king pin. I have seen both. Link to comment Share on other sites More sharing options...
07 HD Posted May 26, 2019 Author Share Posted May 26, 2019 Here are 2 pictures cleaned up as good as could the one fitting towards top on side takes Grease but comes out instantly on top looked real good and felt around cannot find another Grease fitting on or towards bottom Link to comment Share on other sites More sharing options...
Spinneyhill Posted May 26, 2019 Share Posted May 26, 2019 You might find that top seal is not very good if the grease comes out immediately. It should seal tight so grease goes to the bottom bearing? Link to comment Share on other sites More sharing options...
Larry Schramm Posted May 26, 2019 Share Posted May 26, 2019 I had a similar issue with one of my cars. It had the grease fitting on the top of the king pin. What happened was the grease in the pin from age became so hard no grease would go through. I needed to remove the king pin, clean out the grease passage and all was fine. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now