Guest dwurzel Posted August 20, 2014 Share Posted August 20, 2014 A friend recently bought a 1936 Dodge Convertible Sedan. It was restored about 10 years ago and is in beautiful condition. He told me it was running rough at speed, and wondered if I might know why. He knows nothing about cars. I am a tinkerer, but no expert. I have played with a 1931 Model A for the past 30 years. When I looked at the car, I found the plugs fouled and the automatic choke disconnected. Champion Y11C plugs are installed. Can anyone tell me what plugs should be used? Also, before I reattach the choke arm, I wondered if anyone might know why someone would disconnect it. Were there a lot of problems with these devices? Link to comment Share on other sites More sharing options...
Owen_Dyneto Posted August 20, 2014 Share Posted August 20, 2014 From the AutoLite website for 1936 Dodge:306, resistor plug for cast iron head.216, non-resistor for aluminum head.295, non resistor for cast iron head.I believe the OEM automatic choke was the thermostatic/electric Sisson choke, extremely reliable and simple to adjust. One can only guess why it was disconnected. Link to comment Share on other sites More sharing options...
Guest dwurzel Posted August 20, 2014 Share Posted August 20, 2014 Thanks. Do the plugs differ for the type of head because of plug depth or bimetallic corrosion? Link to comment Share on other sites More sharing options...
Rusty_OToole Posted August 20, 2014 Share Posted August 20, 2014 Someone disconnected the choke because they were too stupid to fix it right, or possibly too stupid to know whether it was working or not. Or maybe just stupid.The difference in plugs is most likely to do with heat range. Aluminum disperses heat faster than iron, so might need a hotter plug. Link to comment Share on other sites More sharing options...
Guest dwurzel Posted August 20, 2014 Share Posted August 20, 2014 Remember the old adage that one should never attribute to cunning and planning what can easily be attributed to stupidity? Sounds appropriate to the choke situation. Thanks for the input. Link to comment Share on other sites More sharing options...
hddennis Posted August 20, 2014 Share Posted August 20, 2014 Sweet car, 750 produced, last I knew, about 15 left.Howard Dennis Link to comment Share on other sites More sharing options...
rons49 Posted August 26, 2014 Share Posted August 26, 2014 I believe that the Sisson choke operates in three stages 1. setting the choke valve by pushing down the gas pedal once. That sets the butterfly at half closed along with the fast idle, by contracting the bimetal spring. 2. engage the starter, which by, an Electric charge from the starter terminal, closes the butterfly fully. 3. Release the starter & the current is cut off from the choke and the spring expands to open the butterfly as the engine warms up, eventually fully opening. If the choke does not fully open, then the engine will run too rich. The Sisson will need adjustment or replacement( if the spring is broken). Ron Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now