414TATA Posted March 28, 2012 Share Posted March 28, 2012 These photos are of my rear passenger door on a 1941 Buick Super 51there is a gap between the rear panel and the door. A restorer did not think the car has been in an accident.The rubber seal is gone on most of that side of the door but remains on top and on the post side. I am aware I can purchase the seal by the foot for replacement.My questions are: Is an adjustment of the latch / hinge possible to make this a tighter fit? Could it be because of the partial rubber seal? or both?Also what should I use to hold the new seal in place?The gap in the photo appears wider than in reality and appears to have a seal in place, it does not.Thanks for any help.Wayne1941 Super Link to comment Share on other sites More sharing options...
Mark Shaw Posted March 28, 2012 Share Posted March 28, 2012 Wayne, It is hard to tell by the photos, but the door may have been forced open past the detent device. I suggest you compare measurements with the door on the opposite side to determine where the problem is. I suspect the hinges may have been bent past full open or the door was forced closed with something caught in the door.My $0.02 Link to comment Share on other sites More sharing options...
Guest Grant Magrath Posted March 28, 2012 Share Posted March 28, 2012 (edited) The dovetail wedge on the door adjusts the height of the front edge of the rear door (suicide doors) so that the trim lies up. The hinges should give you the adjustment you're after.CheersGrant Edited March 28, 2012 by Grant Magrath (see edit history) Link to comment Share on other sites More sharing options...
414TATA Posted March 30, 2012 Author Share Posted March 30, 2012 Grant I am pleased to report I was able to adjust the latch and the door now has a much tighter fitThanks very much!Wayne Link to comment Share on other sites More sharing options...
Guest Grant Magrath Posted March 30, 2012 Share Posted March 30, 2012 Duh! Now I look at the pictures properly, I can see what you were adjusting! I offered you advice on everything but the adjustment you wanted Wayne! Sorry!CheersGrant Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now