36Dodge_redo

I am cautiously optimistic that I can get it close enough that an acceptable amount of filler can make it look right. It might not be perfect but it will be mine!

Trying to knock out all the metal work before sending it off to blasting. Found lots of lead in the front fender. Getting it cut out and a new piece back in. Need to work the bead back into the new piece.

Making progress fitting the rear panel.

Posting this in general parts vs the chrysler parts where I had it. This kit came with the 1936 dodge project car I picked up but I am keeping it original so it will not be needed. I am located in Sterling VA. Asking $300.

There are perch mounts, ubolts and spring mounts included. Not part of the MII kit but going with this where ever it goes!

My 1936 D2 project car came with a crossmember kit that I will not be using as I am sticking with the flathead 6. All parts are pictured except for a set of leaf springs that I will be throwing in as well. It appears there was hardware included for rear leafs as well. I am located in Sterling VA. I am asking $300 for the whole lot of it.

My 1936 project car came with a Dodge D-30 flathead 6 block. I do not have a need for the block and am looking for a home or anyone who might need one. If anyone is looking for a 1949 230ci block please reach out. I am located in Sterling VA. Make an offer.

Found a tail pan, need to see about fitting it up, top edge is slanted down towards the trunk, need to understand what this is supposed to look like.

Small progress,

I cant thank you guys enough for the support. I am cautiously optimistic that SRPM streetrods has a tail pan for a 1936 touring sedan. They are supposed to send me a photo today. You all have been amazing, this is quite a community.

You must have some kind of eagle eye working. I was scanning the video while working! I have reached out to them see what they come back with.

Unfortunately they are both coupes

I am reaching out to them, thank you for suggesting.