1940Rudy

It’s a 1940. I have two, one ground w/bearings and one standard size, no bearings. Both 1940

I’ve got a reground crank, .04. Under with ford and main bearings. I also have a good block and new std pistons pins, and rings. Also rods with new bushings.all un-assembled.

Replica wire harness $150 +shipping

Just one. $50 plus shipping.

Hi I’ve decided to keep the rest thanks Edited 4 hours ago by 1940Rudy

$50+shipping

Hi I’ve decided to keep everything thanks

I have a couple single carb manifolds for sale. Good condition, used. I’m having a hard time finding prices for these. I’ll post pictures if you’re interested.

Hi, I’m looking for the best shop manual for my zephyr. It’s in pieces(I got it that way) and I’d like to put it back together. Any suggestions. I need one that covers engine and body. thanks!

I have the same question as the OP. What size do you grind the sealing surface to? What seal do you use? part# please. Thanks

Thanks, I’ll check out both of the people you mentioned.

Are these deflectors not installed in the 1940 V12? It was mentioned above that the factory started putting them in in 1941. Should I put them in mine? Does anyone have a drawing I could make some from, or are they available to buy? Thanks

This is more of a what’s the deal question. So I have three exhaust manifolds here. The two in the top of pic are tha same except they’re left and right side. And they both exhaust near one end. The one on the bottom exhausts out the center. which is correct for my ‘40 zephyr? Also, which side is which? The manifolds look like they could go on either side of the engine.

Lol, well better to take it from this part than the fender.

I found another one that is not chopped up. Is there any reason that they would have modified this?

Found this while unpacking Zephyr parts. Looks like someone decided to crudely cut it for some reason. Any reason why someone would do this? What is it? I’ll need to find one. Thanks

Great, thank you!

So, where does this part go? It’s pretty clean, so I assume under the hood, but I haven’t seen it in any pictures I’ve looked at.

Thank you very much Tom!!

Hi, So I bought a ‘40 LZ club coupe in pieces!! anyways, I’m unpacking everything and found this part that I can’t figure out what it is. I can get more pics if necessary. Any help is appreciated! Tia Rudy