Mars

Sorry wrong forum

Should the plug on top have a vent hole?

Yes

I don't have either so I don't know the proper length.

Need wiper arm and blade for 1930 Desoto cf 4dr sedan

Thanks very much

Here's pics.

Took off the wiper motor,shaft turns back and forth okay,but doesn't move with the vac line is connected. Getting vac pull. Can it be serviced?

30 cf sedan. Wondering if many of you drive these 6 volters at nite? I don't get nearly enough light. Are there other bulbs available?

I stand corrected

That's true if you you're happy with pressure treated lumber. Really depends on the look you want.

Will they see much water? It's almost impossible to maintain that new look. Even exterior poly only lasts so long before the surface fails and water seeps in and stains the wood. Even epoxy only lasts so long. Spokes are self draining and air dried . If water Ian an issue, then use oak, like the wheels. I've had a lot of experience in this dept.

30 cf, I think I have a vacuum leak, coming to a stop with clutch in, it idles abit high until I tap the throttle and it kicks down. How to check? Carb gasket? Thanks

Where can I get the actual wiper arm and blade?

Are there synthetics that compare to detergent oils?

It's not much different than yours. Doesn't look like it in the pic but it's similar

Been reading about u joints on similar models. Mine have a leather covering held on with springs wrapped around. I'm not sure what I'm looking at or what it should be. Thanks

Might the gauge be affected? Being a mechanical pump, how likely is a failure?

I use 30 weight oil in my 30 cf. Started it yesterday for less than a minute, shutting it off when I wasn't getting an oil pressure reading. It was bearly 30 degrees outside, so I'm thinking the oil was just too thick to flow well. Make sense?

Putting in a new windsheild, Any tricks on installing new rubber gaskets. I know they go in after the glass is in.

Straight 140 or multi wt.?

That's agreat idea, thanks!

90 weight, drips at bottom of cover, not a lot. Probably shouldn't worry about it. Reseal with new gasket prob best bet

1930 desoto cf .any ideas on how to stop dripping gear oil?

I took it off to rebuild it. I have everything removed that I can. It’s very close to coming out, just needs to wiggle it just right?