Sign in to follow this  
Fox W.

Oil level sensor intermittent - possible bad wiring

Recommended Posts

Hello,  I started getting an intermittent  low oil level warning upon start-up.  I replaced the sensor, but soon after it came back.  I replaced it again, and the issue is still there, intermittent.   I assume my issue is a bad wire maybe.  I tested the resistance and I think was getting about 2.3ohms.   Does anyone know what it should be?  I assume open would be low, and closed would mean the float is up (level OK)

 

The wires and the connector seem fine.  Resistance didn't change when I wiggled them around.  

Share this post


Link to post
Share on other sites

Try putting a jumper in the connector........if there is a wiring problem you will continue to have the intermittent warning.

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this