panelbeater1234 Posted April 27, 2018 Share Posted April 27, 2018 to all would like to know do i attach to the edge of the bodylip it has 2 slits in the foam rubber .....John Link to comment Share on other sites More sharing options...
jpage Posted April 27, 2018 Share Posted April 27, 2018 John, there may be 2 sizes of rubber for those cars, The most common in the small version which fits a channel about 1/2 -5/8 in wide.If you look at the seal, you'll notice that one groove of the little flap is deeper than the other. The flat square edge of the seal faces the outer side of the channel and is tucked down into the channel allowing the deeper groove to extend over the inner edge of the channel. The smaller lip on the top of the seal is what actually seals the lid as it provides a small channel to drain the water off. I know that this is not the best description but hope it helps some. If you need more I can get a photo of mine that might shed a little more light on it! Link to comment Share on other sites More sharing options...
panelbeater1234 Posted April 27, 2018 Author Share Posted April 27, 2018 Hi john here again if you could send me a photo would be great is just that i dont wont to get i wrong as i will glue it on .Many thanks for your help.....John Link to comment Share on other sites More sharing options...
jpage Posted April 28, 2018 Share Posted April 28, 2018 I'll try to get a photo today out to you. The rubber usually fits so tight you may not need much glue. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now