1940 zephyr V12 engine part out

[1940Rudy]

Hi
I’ve decided to keep everything 

thanks

Edited September 18, 2023 by 1940Rudy (see edit history)

[DWacket]

Deleted

 

Edited November 10, 2023 by DWacket
No longer needed (see edit history)

[rkdinuzzo]

Interested in the aluminum heads... can you post a pic?

Edited June 8, 2023 by rkdinuzzo (see edit history)

[abelincoln]

Tell me about the oil pans.  PM at trades707@juno.com

thanks

[Ray500]

On 4/20/2023 at 2:23 PM, 1940Rudy said:

Hi
I’ve decided to put a small block Ford into my ‘40 Zephyr, so I’ll be selling the components to my V12. 
There’s lots of new and used parts, enough to build the engine and some spares. 
2 blocks
Crank re-ground .040 under with new rod and main bearings. $800
Cam re-ground. No bearings. 
Cam, good used. SOLD
24 pistons and rods, used
1 pair cast iron heads
1 pair aluminum heads $1900
Carburetor zephyr v-12 model 91-99 $200
Carburetor Holley 2100 94 $120
2 oil pans
1 New Melling M15 high volume oil pump- $210
2 intake manifolds- both single carb
1 air cleaner-SOLD
1 transmission 
The rear end will go last, after I get the new one in. 
I’m sure there are things I’m forgetting, just ask. 
I’m not sure on prices right now, I’ll try to figure fair prices. 
If you’re interested, let me know here and I’ll send pictures. 
I’m not sure about shipping on the heavier stuff, but I’m willing to look into it. 
Thanks all.
Fallbrook, Ca.

 

 

Added parts:

Full set of rings, new, standard bore. $140
Exhaust manifolds
Muffler
Exhaust pipe in very good condition. It was probably new in the ‘80s. Never used. 
Generator 
Starter
2 clutch pressure plates
Piston rods new with new bushings $600
New cam gear- not aluminum 
Used valves, springs, keepers, etc. 
Used pistons- standard size
New pistons with pins- standard size $450
Fan with pulley
Fan pulley-no fan
Pair of used water pumps. SOLD
Distributor and coil  $200
Wires caps and tubes-SOLD
Fuel pump with glass bowl

Original radiator. 
original oil pump

oil filter can

 

more parts to come

 

I’m having a difficult time trying to find pricing on these parts, so bear with me. 

Make an honest offer if you see anything you need.

Pictures on request 
Plus shipping on everything.
Prices are negotiable. 

You can download BoosHarrel's parts catalog to see what pricing is current.  Keep in mind he's a retailer and has lots of new parts, so the prices you see in comparison would need to be adjusted accordingly.  

thanks

 

[old crow]

I'm looking for a set of pistons ,rings rods an oilpump some new lifter innerds.also interested in the distributor but need to know the condition. 

I have a running engine but has one bad cylinder bore, so it's in need of an overhaul. thanks