Brooklyn Beer Posted March 10, 2020 Share Posted March 10, 2020 working through issues trying to get this DRT -08 carb sorted out and have checked float and level, jet sizes, etc. The idle tube is not soldered in the screw and need to do that. Can folks familiar with the idle tube tell me if this is correct orientation with the holes in the tube to the screw base before I solder it or do i need to flip it around? Car will not run or idle unless choke is engaged 1/2 way. This one problem I have been told that could be causing it. Carb is clean had been previously rebuilt but not correctly Link to comment Share on other sites More sharing options...
hursst Posted March 13, 2020 Share Posted March 13, 2020 Not sure about your orientation, but you may want to try posting here: http://www.1948plymouth.info/28Q29U/ These guys are all extremely knowledgeable and helpful when I have 30U questions. Link to comment Share on other sites More sharing options...
Brooklyn Beer Posted March 13, 2020 Author Share Posted March 13, 2020 Thank you! I contacted them to get registered. Just skimming through the threads I can see these guys live and breath flat 4's. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now