Sactownog Posted May 1, 2019 Share Posted May 1, 2019 what is the best way to prop engine up while I remove rubber bushings under bell housing and above on top of the bell housing? should I put a jack under the oil pan with a piece of wood holding it up while pieces get sent out? Link to comment Share on other sites More sharing options...
Taylormade Posted May 1, 2019 Share Posted May 1, 2019 If you hold it up by the oil pan you risk crushing the cork gasket or collapsing the oil pan. I’m not sure how close your car is to my 32DL setup, but I removed the lower bellhousing cover and then supported the motor by putting a support on the front ledge of the bellhousing. 2 Link to comment Share on other sites More sharing options...
Sactownog Posted May 2, 2019 Author Share Posted May 2, 2019 6 hours ago, Taylormade said: If you hold it up by the oil pan you risk crushing the cork gasket or collapsing the oil pan. I’m not sure how close your car is to my 32DL setup, but I removed the lower bellhousing cover and then supported the motor by putting a support on the front ledge of the bellhousing. i will try this, thank you for the tip. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now