Guest 1Packard Posted May 20, 2012 Share Posted May 20, 2012 Parting 1930 Packard burn victim. Disk wheels, brake parts, shocks, bumpers, door shells, radiator (recently gone through). Engine, rear end. (was told had a tall gear). began pulling generator, starter, carb & manifold (no broken bolts removing manifold. . Ran before house fire rendered her a total loss. Radiator shell just began surface rusting as did the bumpers. All wood is gone. Dash is salvageable, but not pulling unless someone needs it. Car is located just north of Houston, TX. Link to comment Share on other sites More sharing options...
tfee Posted May 30, 2012 Share Posted May 30, 2012 1Packard, is any of the bodywork salvageable? I need rear seats as well but not if the springs have been cooked in the blaze. Could you post some pictures by any chance?Thank youTodd Link to comment Share on other sites More sharing options...
Guest 1Packard Posted June 4, 2012 Share Posted June 4, 2012 Todd,Thanks for the reply. This car endured some heat. Salvageable parts include the drive train, block, radiator, shell & shutters, starter, generator, disc wheels, (have not had drums off yet.) Bumpers are straight, but needing rechrome. Have LH front fender with sidemount hardware for both sides. Dash is probably salvageable. Rear fenders are nice. Door shells are good but the wood was burned. For some reason, I cannot load pictures, maybe because I'm a Jr. member. Just email me at kbarker300@earthlink.net for pictures. Link to comment Share on other sites More sharing options...
Guest ray17025 Posted June 6, 2012 Share Posted June 6, 2012 tfee, between us, we could likely use all of these parts! Link to comment Share on other sites More sharing options...
Guest lingmar Posted June 6, 2012 Share Posted June 6, 2012 I could use sidemount hardware. Both sides. Pie plates, bolts, locks if they're available. Put a price on them if you would. Contact directly mdlbandc@comcast.net. thanks, Mark Link to comment Share on other sites More sharing options...
Guest ray17025 Posted June 9, 2012 Share Posted June 9, 2012 At the very least, I need those rear fenders ------raytennyson@embarqmail.com Link to comment Share on other sites More sharing options...
tfee Posted June 11, 2012 Share Posted June 11, 2012 Ray, we may have to wrestle over those rear fenders! LOL Link to comment Share on other sites More sharing options...
MikeDeFelice Posted January 10, 2013 Share Posted January 10, 2013 Did the Disk Wheels Sell? Link to comment Share on other sites More sharing options...
Guest jd51 Posted March 30, 2013 Share Posted March 30, 2013 I could use both front fender braces. thanks, jdietz51@hotmail.com Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now