Jump to content

1923 Special 6 - springs on bolts connecting gas tank to frame


Recommended Posts

If you have an old one, measure the outside diameter of the coils, inside diameter, wire diameter, free length, and number of of coils. Assume they are standard "music wire" steel springs. Go to Precision Spring Manufacturer - Century Spring Corp. and do a search for a compression spring that is close.

When you tighten the bolts, the spring should only compress a little, leaving room for further compression under transient load. I haven't seen the tank, but let's assume it holds 20 gallons of gas at 6 lb/gal or 120 lbs plus the weight of the tank, say 30 lbs. That makes a total of 150 lbs or 50 lbs per spring. So, the springs should be holding the tank against the brackets even when the tank is full. If you have a spring rate of 200 lb/inch, the springs will be compressed 1/4" or a little more for the pre-load. The coils shouldn't be touching each other when the car is parked so that the tank can move a little bit when you hit a bump or the chassis twists a little.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...