rjp
-
Posts
1,043 -
Joined
-
Last visited
Content Type
Forums
Gallery
Events
Posts posted by rjp
-
-
-
I would be glade to get that from ya if you're willing to part with it. do you have any of the other linkage that goes up to the vent door?
-
If I tour into my transmission would anyone have trans gears if missing a tooth? I dont know for sure yet. Thanks Roger 1923 Studebaker light 6 Touring
-
What could one expect of the worst price to over haul a 1922 special 6 engine? poring bearings and everything? Thanks Roger
-
Did the 23 special 6 touring have a visor. and if so what kind of props did it have?
-
It would be for the screw type. I have the piece in the dash and ws wondering what it was for. Yes I would be interested. I dont have the knob, just the piece that mounts in the dash. Thanks Tell me more
-
Can anyone help me with the linkage for the cowl vent on a 23 Studebaker special 6? Thanks Roger
-
Looking for the toe plates that go around the steering column and peddles on the toe board of 30,31,32 chevys. Thanks Roger
-
I just got it.!!! great book, takes a little bit to figure it out but, its in there. Roger
-
Thats helps alot, Thanks Ill be on the look out. Thanks again
-
Top bow saddles for a 23 Studebaker special 6 Touring. I dont know if the mounts should be top middle of bottom of the saddle. They are the type that slide in a pipe for mounting Thanks any help would be appreciated. Thanks again Roger
-
The saddles that I found mounts correctly , But I dont know if the mounting should be top, center, or bottom. Can any one help? Thanks it is for a 23 studebaker special 6 touring
-
-
Would anyone have a dash lamb that would be close to working on a 23 studebaker special ^ Thanks Or a picture
-
Thank you very much, I just ordered it Thanks again Roger
-
Thank you that gives me some leads. Roger
-
Working on my 1923 special 6 clutch. I put new lining and new clutch brake pad. Can anyone walk me through the adjustments? The clutch works great but, does not look at this time that the throw out bearing is going to hit the clutch brake soon enough. Any adjustments?? Thanks. how about, how should I adjust the 3 fingers ,just take the slack out?? Thanks any thing would be appreciated Thanks again Roger
-
Looking for 1920's instrument dash light for a car. The one that is mounted separate and shines down It would be mounted on a wood dash so the threads have to be a little longer Thanks Any make will work. It is for a 23 Studebaker Thanks again Roger
-
Iam working on a 1923 Studebaker special 6. Iam looking for maybe a pattern or possible purchase of the friction pads on the spark and throttle levers up on the column. What would be a good material to make them out of.? Thanks. Would they be the same as any other car? Roger
-
Found some That I think will work. Thanks
-
I think I have it covered. Thanks
-
The book I had had a cone clutch, not mine it has 2 friction discs. 12inch od. Anyone one know where to go for them Thanks
-
I have a 1923 sudebaker special 6 touring. Can some one take a picture or 2 of the spare tire rack in the back so I can see what Iam looking for? thanks
-
Thank you, my car is a 1923 Studebaker special 6 touring. Bob is in calf. ? would any one have a phone number Thanks again
cowl vent
in Studebaker, Erskine & Rockne
Posted
Sent a PM